Philips HI5919/30 - Инструкция по эксплуатации - Страница 6

8

Troubleshooting

This chapter summarizes the most common problems you could encounter with the appliance. If you are unable to 
solve the problem with the information below, visit

 www.philips.com/support 

for a list of frequently asked questions or 

contact the Consumer Care Center in your country.

Problem

Possible cause

Solution

The iron does not produce 
any steam.

You have set the temperature dial 
to SYNTH to  .

Turn the temperature dial to     or higher.

The steam function has 
been disabled until you have 
performed the Calc-Clean 
process.

Perform the Calc-Clean process to restore the 
steam function. (see chapter 'Cleaning and 
maintenance')

At the start of your ironing 
session, the steam trigger has not 
been pressed long enough.

Press and hold the steam trigger until steam comes 
out. It may take up to 30 seconds until steam comes 
out.

The Calc-Clean light flashes. 
No steam comes out of 
the soleplate and/or the 
appliance beeps.

You have not done or have 
not completed the Calc-Clean 
process.

Perform the Calc-Clean process to enable the 
steam function again (see chapter 'Cleaning and 
maintenance').

The appliance has switched 
off.

The auto shut-off function is 
activated automatically when the 
appliance has not been used for 
more than 5 minutes.

To activate the appliance again, set the on/off 
switch to ‘off ’ position and then to ‘on’ position. 
The appliance then starts to heat up again.

The appliance produces a 
loud pumping sound.

The water tank is empty. 

Fill the water tank with water and press the steam 
trigger until the pumping sound becomes softer 
and steam comes out of the soleplate.

Water droplets comes out of 
the soleplate.

After the Calc-Clean process 
remaining water may drip out of 
the soleplate.

Wipe the soleplate dry with a piece of cloth. If the 
Calc-Clean light still flashes and the appliance still 
beeps, perform the Calc-Clean process (see chapter 
'Cleaning and maintenance').

Dirty water and impurities 
(brown stains, white flakes, 
etc.) come out of the 
soleplate.

Impurities or chemicals present in 
the water have deposited in the 
steam vents and/or soleplate.

Performs the Calc-Clean process regularly (see 
chapter 'Cleaning and maintenance').

Water flushes out of the 
soleplate.

You have accidentally started the 
Calc-Clean process (see chapter 
'Cleaning and maintenance').

Switch off the appliance. Then switch it back on 
again. Let the iron heat up until the 'iron ready' light 
lights up steadily.

English