Philips GC6722/20 - Инструкция по эксплуатации - Страница 7

9

Cleaning the soleplate

To properly maintain your appliance, clean it regularly.

1 

Clean the appliance with a moist cloth.

2 

To easily and effectively remove stains, let the soleplate heat up and move the iron over a moist cloth (Fig. 20).

Tip: Clean the soleplate regularly to ensure smooth gliding.

Storage

1 

Switch off the appliance and unplug it.

2 

Pour the water out of the water tank into the sink (Fig. 21).

3 

Fold the mains cord and water supply hose together. Push them into the storage compartment (Fig. 22).

4 

For GC6730, GC6740 series only: push the carry lock release button to lock the iron onto the iron platform (Fig. 23). 
You can carry the appliance by the handle of the iron when it is locked onto the iron platform (Fig. 24).

Troubleshooting

This chapter summarizes the most common problems you could encounter with the appliance. If you are unable to 
solve the problem with the information below, visit

 www.philips.com/support 

for a list of frequently asked questions or 

contact the Consumer Care Center in your country.

Problem

Possible cause

Solution

The iron does not produce 
any steam.

There is not enough water in the 
water tank.

Fill the water tank beyond the MIN indication. 
Press and hold the steam trigger until steam 
comes out. It may take up to 30 seconds until 
steam comes out.

You did not press the steam trigger. Press and hold the steam trigger until steam 

comes out.

The steam function has been 
disabled until you have performed 
the Calc-Clean process.

Perform the Calc-Clean process to restore the 
steam function. (see chapter ' Cleaning and 
maintenance')

At the start of your ironing session, 
the steam trigger has not been 
pressed long enough.

Press and hold the steam trigger until steam 
comes out. It may take up to 30 seconds until 
steam comes out.

You have set the temperature dial 
to 

●

.

Steam is not available at 

●

. To use the steam, 

set the temperature dial to 

●●

 or higher.

The light of the CALC-CLEAN 
button flashes and the 
appliance beeps.

This is the Calc-Clean reminder.

Perform the Calc-Clean after the Calc-Clean 
reminder is given (see chapter ‘Cleaning and 
maintenance’).

No steam comes out of the 
soleplate, the light of the 
CALC-CLEAN button flashes 
and the appliance beeps.

You have not done or have not 
completed the Calc-Clean process.

Perform the Calc-Clean process to enable the 
steam function again (see chapter ‘Cleaning and 
maintenance’).

The appliance has switched 
off.

The auto shut-off function is 
activated automatically. The 
appliance enters the standy mode if 
it has not been used for 15 minutes 
and switches off if it has not been 
used for another 10 minutes.

To swith on the appliance again, set the on/off 
switch to “off” position and then to “on” position.

The appliance produces a 
loud pumping sound.

The water tank is empty. 

Fill the water tank with water and press the 
steam trigger until the pumping sound becomes 
softer and steam comes out of the soleplate.

English