Braun IS2043BL CareStyle - Инструкция по эксплуатации - Страница 16

16

Troubleshooting guide

PROBLEM

CAUSE

REMEDY

The appliance does not pro-
duce any steam.

There is not enough water in the 
water tank.

Unplug the appliance; check if the 
anti-limescale fi lter cartridge  has 
been well prepared and is placed 
properly; fi ll water up to max. level; 
close the lid of the water tank; plug 
in and wait until the temperature 
control LED is permanently on; 
press the steam button until steam 
comes out of the soleplate. 
In case above procedure does 
not solve the problem take the 
following steps: press RESET + 
steam buttons together until steam 
comes out. Once steam comes out, 
release the buttons.

The steam button has not been 
pressed.

A new anti-limescale fi lter car-
tridge  has just  been installed. 

The anti-limescale fi lter  cartridge  
is not placed properly.

The anti-limescale  indicator is 
on and less or no steam comes 
out of the iron when pressing 
the steam button. 

The anti-limescale fi lter  cartridge  
needs to be replaced. 

Replace the anti-limescale  fi lter 
cartridge and  press the reset 
button  for 5 seconds until the LED 
turns off .  
You can also use demineralised wa-
ter. In that case, you need to leave 
the anti-limescale fi lter cartridge  
in the compartment and press the 
reset button  for 5 seconds each 
time the the antilimescale indicator 
turns on.

The appliance emits a loud 
noise associated with vibra-
tions (subtle pumping sound is 
normal).

A new anti-limescale fi lter car-
tridge  has just been installed.

Continue to press the steam button 
until the loud noise stops and steam 
comes out of the soleplate.

The water tank is empty.

Refi ll the water tank and press the 
steam button until the loud noise 
stops and steam comes out of the 
soleplate.

The anti-limescale fi lter  cartridge  
is not in place.

Place the anti-limescale fi lter car-
tridge  in the compartment.

The anti-limescale fi lter  cartridge  
is damaged or shows cracks.

Inspect the anti-limescale fi lter car-
tridge  thoroughly. If you see any 
sign of damage or cracks, replace 
the anti-limescale  fi lter cartridge  
with a new one.

The fi rst time the appliance is 
turned on, you notice smoke 
/ smell.

Some parts have been treated 
with sealer/lubricant which 
evaporates the fi rst time the iron 
heats up.

This is normal and will stop when 
you have used the iron a few times. 
If the smoke/smell is still present 
after turning off  the appliance, con-
tact an authorised Braun Customer 
Service.

There is too much steam 
coming out of the iron.

Mode turbo is on.

Activate the iCare or eco mode by 
pressing the mode button.

5712811981-01_CareStyle_1_INT_S6-152.indd   16

08.06.18   11:14