Braun 2830020-IS3157BL - Инструкция по эксплуатации - Страница 11

11

Troubleshooting guide

PROBLEM

POSSIBLE CAUSE

SOLUTION

The iron does not 
produce any steam

When starting your ironing session the 
steam button has not been pressed 
long enough

Press and hold the steam button until 
steam comes out. It may take up to 30 
seconds until steam comes out

There is not enough water in the water 
tank 

Fill the water tank

If the clean system LED turns on, the 
steam function has been disabled 
until you have performed the cleaning 
process

Perform the cleaning process ( see 
dedicated chapter)

The iron is heating up

When the temperature control LED 
is fl ashing, the iron is heating up; 
during this phase the steam function 
is disabled. Wait until the temperature 
control LED turns permanently on.

The appliance has 
switched off 

The auto-off  mode is activated 
automatically when there has been 
no steam emission for more than 20 
minutes

Press the On/Off  button to re-activate

During steam 
emission the system 
produces a pumping 
noise associated 
with vibrations

If the water tank is full - this is a normal 
working condition

No action required

The water tank is empty

Switch off  the system, unplug and fi ll 
the water tank. Press the steam button 
untill the steam comes out.

Water droplets come 
out of the soleplate

Steam condenses into water in the 
hose when you use steam for the fi rst 
time or have not used it for a long time

This is normal. Hold the iron away 
from the garment and press the steam 
button. Wait until steam instead of 
water comes out of the soleplate

During ironing 
white particles 
and impurities are 
coming out from the 
soleplate

Your tap water is very hard

If your tap water is hard we recommend 
you use either distilled water or 
demineralized water

Impurities of chemicals present in the 
water have deposited in the steam 
vents and/or soleplate

Perform the cleaning process regularly 
even if not required by the system 

Water fl ushes out of 
the soleplate

The cleaning process has been 
activated accidentally. 

Switch off  the appliance and unplug. 
Put the iron on the cleaning vessel, 
switch on and perform the cleaning 
process completely ( see dedicated 
chapter)

The fi rst time the 
appliance is turned 
on, you notice 
smoke / smell

Some parts have been treated with 
sealer / lubricant which evaporates the 
fi rst time the iron heats up

This is normal and will stop after the 
iron has been used a few times. If 
the smoke/smell is still present after 
turning off  and cooling down, contact 
an authorized Braun Customer Service

All Leds are fl ashing

System error

Unplug the system, plug in again. If 
the problem is still present unplug 
immediately and contact an authorized 
Braun Customer Service

5712812331_IS3132_3155_3157_INT.indd   11

26.03.20   15:11