Bort SteamCare Plus - Инструкция по эксплуатации - Страница 8

8

ENGLISH

GB

STEAM GENERATOR

GENERAL INFORMATION

Dear Customer, Please read and comply with these original 
instructions prior to the initial operation of your steam gen-
erator and store them for later use or subsequent owners .

PREPARING FOR USE 

- Remove the water tank (5), fill water tank up to the 

level marked MAX and reinstall it .

- Turn on the device using the OFF / ON mode switch 

(2), check that power indicator is lighting (11)

- Set the temperature controller to the required level .

When choosing the temperature regime, follow the label 

instructions on the products you are going to iron. If 

label is absent, use temperature according type of fabric: 

(table1)

TECHNICAL SPECIFICATIONS (fig . 1)

Power

2 200 W

2 350 W

SteamCare

SteamCare

Plus

Max

pressure

3,5 bar

4 bar

Continuous

steam

50 g/min

55 g/min

Steam temperature

98 °С

Tank capacity

1 100 ml

Heating time

60 sec

Continuous working 

time

20 min

Hose leghth

1,6 m

Cable length

1,5 m

Type of sole

Ceramic

Vertical 

steam

+

System of protection 

from scale

+

Voltage

230 V

Current frequency

50-60 Hz

Product weight

2,4 kg

TABLE 1

The 

fabric is not 

ironed

Nylon, 

Acrylic, 

Synthetics

Silk, 

wool

Cotton, 

linen

Recommended 

temperature

Iron 

temperature 

level

Low

•

Middle

• •

High

• • •

Label

Type 

of fabric

MANUAL
Steam Ironing

1.

Choose necessary temperature on the iron 

according type of fabric (table 1) .

2. 

Wait «steam ready» indicator light (9) but the iron 

heating indicator (10) goes off . Press the button (3) 

to turn on the continuous supply of steam from the 

soleplate .

3. 

To stop the continuous steam supply, press the 

short-time steam button (12) .

4. 

For short-term steam supply - keep pressed button 

(12) . To stop the steam supply, release the button (12) 

and supply of steam will stop

5. 

If during operating water is finished, the indicator 

«fill water» (8) will light on the panel . Steam supply will 

stop . Fill the water tank (see “

Preparing for use

”)

6. 

At the end of ironing, select the temperature of the 

iron in the “0” position . Then turn off the power and 

drain water tank .

TROUBLESHOOTING

•  Often, failures have simple causes and you can do the 
troubleshooting yourself using the following overview . If 
you are in doubt or if the failure is not listed here please 
contact the authorized customer service .
•  Repair works may only be performed by the authorized 
customer service . Always disconnect the mains plug and 
allow the steam cleaner to cool down before performing 
any maintenance work .