Timberk TAP FL600 MF - Инструкция по эксплуатации - Страница 7

www.timberk.com • electric air purifier

7

In case of emergency contact information listed in the table 2 below. If you 

can not solve problems independently, to a service center.

8. TROUBLESHOOTING

Table 2

Problem

Check

Solution

Appliance does not turn ON

• Power 
• Power 
• Cover

• Plug in power cord
*Press the power button
*Make sure the cover is securely closed

Red «CLEAN CELL» indicator 
has illuminated

Collector cell

Red «CLEAN CELL» indicator is a 60 day cleaning 
reminder. Wash collector cell. Make sure it is 
thoroughly clean before reinstalling

Red «CLEAN CELL» indicator 
is blinking

Collector cell

• When a large particle is captured in the collector cell, 
please restart your appliance
• A fast blinking light indicates the power supply 
has shut down due to arcing or short circuit. The 
cell should be inspected and cleaned, repaired, or 
replaced

Collector cell does not remove 
particles 

Collector cell

• Clean the collector cell
• Collector cell may be damaged. Contact authorized 
service center

Appliance sparks, crackles 
and pops

Collector cell

• Sparking or poping noise (arcing)can  occur 
when a large particle is captured in the collector 
cell or appliance is used in over damp rooms. If the 
appliance is arcing excessively, the cell may be dirty. 
Try cleaning the collector cell.
• If  excessive arcing continues after proper cleaning, 
the collector cell may be damage.  If damager, contact 
authorized service center. 

«AUTO» light is blinking

Surroundings

Air qulity is very bad, please open the window to 
improve the ventilation

Odor sensor

Odor sensor get malfunction, should be repaired 
or replaced

Term reliability is 5 years.
At the end of the life of the puripier should be subjected to disposal in 

accordance the rules, regulations and methods, at the place of disposal.

9. UTILIZATION

10. TRANSPORTATION AND STORAGE

1. When transporting, any possible impacts and movements of the 

package inside a vehicle must be avoided. 
2. Handling symbols on the unit’s package must be strictly observed when 

transporting and storing it.
3.

Temperature 

requirements*
Humidity 

requirements*

Transportation and 

storage

-30°C to +50°C

15% to 85%       

(no condensate)

We are researching new technologies and constantly improving the quality 

of our products. Specifications, design and scope of delivery may be 

changed without any prior notice.

* Products must be stored in dry, ventilated storages at the temperature 

not lower than -30°C.