BEURER LR 200 - Инструкция по эксплуатации - Страница 16

16

Display and buttons

3

4

2

1

ON/OFF FILTER RESET 

I 

II  III  

ION  SLEEP 

2H  4H  8H

1 ON/OFF button 

Switches the device on/off

If the light below “Filter reset” is flashing, change 

the filter. After changing the filter, hold down the 

on/off button to reset the filter change display.

3 Ioniser/Sleep mode 

Switching the ioniser or night mode on/off..

2 FAN SPEED button 

The air cleaner has three fan speeds: I (low), II 

(medium) and III (high).

4 TIMER button 

The air cleaner features a timer function that you 

can use to determine the number of hours the 

air cleaner should run for before it automatically 

switches itself off. The air cleaner has three timer 

periods: 2H (two hours), 4H (four hours) and 8H 

(eight hours).

5. Initial use

5.1 Removing the air cleaner

1.  Open the cardboard packaging.
2.  Remove the device from the top of the box without opening the film bag.
3.  Now remove all plastic films. Remove the combi filter from the device (see “Filter change” section) and 

take it out of the plastic film. Then re-insert the combi filter into the device.

4.  Check the device, mains plug and cable for damage.

5.2 Setting up the air cleaner

1.  Place the air cleaner on a firm, level surface to prevent vibrations and noise.

 IMPORTANT

If you wish to reposition the air cleaner, only carry it by the handle on the rear of the device.
2.  Set up the air cleaner in such a way that there is at least 30 cm clearance on all sides.
3.  Make sure that the air inlet and air outlet are never blocked.

6. Operation

6.1 Switching on the air cleaner 

1.  Always follow the instructions in chapter “5 Initial use”.
2.  Insert the mains plug into the socket. Ensure that the cable does not pose a trip hazard.
3.  Press the ON/OFF button ( ) to switch on the air cleaner.