Обогреватели Timberk TOR 21.1809 DC - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
IM2021
17
7.
ASSEMBLY AND INSTALLATION
1. Unpack the radiator and roller wheels and remove all the packaging material.
2. Put the radiator upside down on a carpet or soft surface, to avoid damage to
lacquer coating.
3. Install wheel plates on the lower part of radiator sections using U
-
shaped
brackets and finger nuts, into two fixed supports.
4. Tighten finger nut on one side and finger nut
on the other –
in clamp extensions
passed through the wheel plate supports, after making sure that 2 openings in the
wheel plate match together with the clamp extensions.
5. Turn the radiator back on the wheels.
Fig. 2
IMPORTANT!
1. Switch on and operate the radiator only when it is in vertical position (with wheels
below and control elements above). Any other position may cause a dangerous
situation and result in failure of the oil
-
filled radiator or damage of property.
The
manufacturer will consider this as a non
-
warranty case.
2. Do not switch the radiator on, if roller wheels are not installed.
8.
OPERATION OF THE DEVICE
1. Before starting to use the device read section «Safeguards».
2. Connect the unit’s power cord to
an electric outlet, observing all of the mentioned
precautions. Remember that you can connect the unit to electric mains only if the
power mode knob is in OFF position, which means the knob should be rotated against
the stop counterclockwise.
3. It is also preferable to turn the thermostat knob against the stop counterclockwise.
Then you can connect the unit to electric outlet.
4. Set the unit’s power mode knob to position “
1
”, “
2
” or “
3
” (low, medium and
maximum heating power respectively). Remember that the higher heating power you
choose, the faster the unit heats the air. But at a low power you save electric power
and reduce the load on your electric mains.
5. After you chose heating power, you need to choose heating temperature. Turning
the thermostat knob clockwise (from MIN position to MAX position), you adjust the
temperature you need. After you choose the temperature (and after you chose heating
power mode, see 4.) the oil
-
filled radiator will start to heat.
