Timberk TFH T20FSN.LZ - Инструкция по эксплуатации - Страница 6

www.timberk.com • Electric fan heater 

6

Unit operation

1. Before inserting the plug into an electrical outlet, make sure that the 

electrical supply in your area matches that on the rating label on the unit.

2.  When  plugged  in,  turn  on  the  Main  power  switch  (1)  at  the  rear  of  the 

upper of the heater
3. When in Standby mode, only ON/OFF on the control panel will respond 

to your touch. Press «» to access the rest of the control panel.

•  Low  Power/High  Power  touch  «Mode»  once  1000W,  touch  again 

2000W,then off heating function

•  Setting  the  temperature:  the  temperature  in  system  is  26°C  when  the 

power in on. Press «     » or «     »  to setting the temperatures for the 

heating, it is from 15°C to 35°C, the LED display shows the Ambient 

Temperature in the room.

• TIMER: Press «TIMER» repeatedly to set a period after which the heater 

will turn itself off  (between 0 hour – 9.0 hours),each press is 1 hour.
• ON/OFF, turn on or turn off item,  item always keep working 30 seconds 

of cool air after turn off it, this design can protect item use longer.

Remote controller (RC)

Remote controller must be directed to the signal receiver, located on the 

fan heater. The fan heater confirms receipt of the control command by a 

sound signal.

1. Button «POWER»
Is used to turn on/off the device in standby mode
2. Button «MODE»
Used to select the heating power or ventilation mode without heating
3. Button «      »
Used to set the desired temperature value or timer
4. Button «TIMER»
Used to select the mode of timer set
5. Button «      »
Used to set the desired temperature value or timer

Mounting of batteries

The  remote  controller  is  power  supplied  from  two  AAA  batteries  (not 

included in the scope of delivery), installed in a special compartment whose 

cover is located on the back panel of the remote controller. To mount 

batteries:
1. Remove the cover of the battery compartment by sliding it along the 

direction of the arrow.
2. Mount batteries, observing specified polarity.
3. Place the cover back.

Fig. 3

1
2
3
4
5

IMPORTANT! 

External appearance of the remote controller may 

be altered by the manufacturer without notice of the 

consumer to modify it and improve its external design.
After switching off, the unit will operate in the fan only 

mode to cool down heating elements for about 30 

seconds. Then the fan heater will be switched off.