Timberk TEC.E15 DG 1000 - Инструкция по эксплуатации - Страница 4

www

.timberk.com • electric convector heater

4

Use the  convector only on flat dry surface.
21. The convector heater has hot sparking parts inside. Do not use it in 

areas where gasoline, paint or other flammable liquids are used or 

stored.

22. Use this convector heater only as described in this manual. Any other 

use not recommended by the manufacturer may cause fire, electric 

shock or injury to persons.

23.  Always unplug the convector before cleaning. Do not submerge the 

convector. Never pull the cord.

24. Avoid the change of a cord and the use of an extension cord because 

it may cause overheat and a risk of fire, as well as damage of internal 

electrical network. However, if you have to use an extension cordits 

parameters should correspond to the appliance power and not be 

used by other power consumers.

25. For normal work of the appliance the voltage level of power network 

should be sufficient and its technical parameters should be in strict 

correspondence to technical parameters indicated on the appliance 

case. If needed, find out specifications of your network from power 

supplier.

26.  Install and operate the appliance only when upright. Do not operate 

the appliance in the horizontal or on the slant.
The appliance should be installed in the way that the control panel 

could not be accessed by a person being in a bathtub (in contact with 

water) or showering.

27.  It is forbidden to install the appliance under a convenience outlet or an 

electric cable, when output heat flows affect them. It may result in their 

overheating and develop an emergency situation.

28. The appliance is not intended for use by handicapped persons 

(including children) with insufficient experience and knowledge, if they 

are not under observation or have not been instructed in the use of 

appliance from a person responsible for their safety. Make sure that 

children do not play with the radiator.

3. TECHNICAL CHARACTERISTICS

Model

Rated power 

consumption, 

W

Power supply, 

V/Hz

Rated

curren, 

A

Protection 

class

Electric 

protection 

class

Net 

weight, 

kg

Device 

dimensions, 

mm

TEC.E15 M 1000

1000

220~/50

4,5

IP24

Class I

5,4

613x88x450

TEC.E15 M 1500

1500

220~/50

6,8

IP24

Class I

6,4

770x88x450

TEC.E15 M 2000

2000

220~/50

9,1

IP24

Class I

7,6

890x88x450

TEC.E15 DG 1000

1000

220~/50

4,5

IP24

Class I

5,4

613x88x450

TEC.E15 DG 1500

1500

220~/50

6,8

IP24

Class I

6,4

770x88x450

TEC.E15 DG 2000

2000

220~/50

9,1

IP24

Class I

7,6

890x88x450

TEC.E15 GL 1000

1000

220~/50

4,5

IP24

Class I

7,2

613x88x450

TEC.E15 GL 1500

1500

220~/50

6,8

IP24

Class I

8,6

770x88x450

TEC.E15 GL 2000

2000

220~/50

9,1

IP24

Class I

9,8

890x88x450

Table 1

For a detailed description of technical parameters and characteristics go to 

www.timberk.com or contact TIMBERK official dealers.

IMPORTANT! 

The manufacturer reserves the right to change the set-list 

of the device (including liquid and powder components) 

for different supplies without prior notice. The changes 

either in no way influence the basic technical parameters 

of the device or may improve them, and also not violate 

the legislation or quality standards of the countries of 

manufacture, transit and selling.
The changes in the set-list may result in changing of the 

weight and dimensions of the device, but not more than 

by +\- 5-20% (depending on the product category)