Обогреватели Timberk T-HG2-Q10T - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
IM2022
13
8.
OPERATION OF THE DEVICE
Fig. 2*
*The appearance of the control panel may differ from the images in the manual
Operating mode selection knob
Used to select the following operating modes: ventilation mode
, heating mode
Thermostat knob
Used to set the room heating temperature
Operation of the fan heater
1. Turning on
Make sure that the operating mode selection knob is set to
position, then connect the device to the
power source and set the operating mode selection knob to
position, the electric motor of the device will
turn on and the device will start operating in ventilation mode.
2. Heating power selection
2.1. Set the operating mode selection knob to
position to select heating mode.
3. Temperature setting
3.1. The room tem
perature can be set in the range from 0 to +40 °C.
3.2. In heating mode, turn the thermostat knob fully clockwise, if the room temperature is lower than the set
temperature, the heating elements will turn on. When the room temperature reaches the desired l evel, turn
the thermostat knob counterclockwise until the heating elements turn off.
Now the thermostat will maintain the set temperature automatically, by turning on and off the heating
elements, the motor will work.
ATTENTION!
1. The first time the device is turned on, a specific odor and smoke may appear (oil is burned from the
surface of the heating elements). It is recommended to turn on the curtain in heating mode for 10-20 minutes
in a well-ventilated area.
2. After transportation or storage of the device at below 0
0
C temperatures, it is necessary to store it in the
room where operation is supposed to be, without turning the device on for at least 2 hours.
After prolonged storage or break in use, do not turn on the device in high heating power m ode.
ATTENTION!
Frequent triggering of the emergency shutdown device is not normal mode of operation of the device. In this
case make sure that the device is really defective and contact an authorized service center.
