Обогреватели Scarlett SCA H VER31 2000 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
IM2022
20
Figure 2
Attention!
The device must be used only with the support feet installed or mounted on the wall.
Operation of the convector without supporting feet or without installation on the wall is
prohibited!
Connecting to the network
1. Convector is designed for connection to the socket with single-phase voltage
220- 240V~/50Hz.
2. Before connecting, make sure that the voltage is correct as specified on the
nameplate with the technical data of the device.
3. When connecting the convector to the mains, the applicable electrical safety
rules must be observed.
4.
Electric outlet must be properly grounded. The socket must be rated for at
least 10A. Electrical plug and socket must always be dry to prevent electrical
leakage. Regularly check that the electrical plug is firmly connected to the
outlet. Check the plug in the following order: insert the plug into the socket.
After half an hour, turn off the convector and unplug the power cord, check if
the plug is warm with the hand. If the plug is heated to a temperature above 50
°C, in order to avoid damage, accidents, fire, due to poor electrical contact
replace the socket with help of a specialist.
Attention!
It is forbidden to operate the convector in the electrical network without grounding.
