Обогреватели Scarlett SC-254 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
IM007
www.scarlett.ru
SC-252/253/254
4
GB
INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS
•
Please read all the instruction manual before use and save it for future references.
•
Before first switching on check that the voltage indicated on the rating label corresponds with the mains voltage in your
home.
•
For home use only. Do not use for industrial purposes. Use the appliance only for its intended use.
•
Do not use outdoors or in damp area.
•
Do not immerse the appliance and the cord in water or other liquids.
•
Do not use the appliance in immediate proximity to bath, shower or swimming pool.
•
Never pull the cord while disconnecting from the power outlet; instead, grasp the plug only and pull to disconnect.
•
Do not allow the cord to touch sharp edges and hot surfaces.
•
Always unplug the appliance from the power supply when not in use.
•
Do not operate the appliance with damaged cord or plug, or after the appliance malfunctions, or has been dropped or
damaged in any manner. To avoid the risk of electric shock, do not disassemble the appliance; take it to a service
center for examination, repair or mechanical adjustment.
•
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliances by a person responsible for their safety.
•
Children should be supervised to ensure that they do not play with the appliance.
•
Do not leave appliance unattended while operating.
•
The heater can be fastened to a wall and ceiling (Fig. 1).
•
The appliance must be used only in the horizontal position (Fig.2).
•
Unit surface temperature of the appliance is high, thus do not touch it.
•
Operating unit should be far away from the flammable or easy bulging under high temperature objects.
•
The heater must not be located immediately below a socket-outlet.
CAUTION:
•
To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.
•
Do not cover the appliance when in use.
ASSEMBLING
•
Before assembling the heater unpack the package and put all parts near the assembling pla e.
•
Assemble the telescopic stand as shown in fig. A.
•
Check the lamp assembly according to fig. B.
•
Fix the lamp on the telescopic stand.
•
Place heater normally and make sure that it is inconvertible.
•
After assembling, the heater is ready to use.
USING THE APPLIANCE
•
Set the mode switch to minimum position.
•
Insert the plug to the power supply.
ATTENTION:
•
Should the unit overheat, provided safety device will switch it off automatically. In such case switch the appliance off
and unplug it. Try to restart again after at least 5 minutes. If it does not operate, contact a Service center.
THERMOSTAT
•
Set thermostat to maximum position.
•
When the temperature rises to satisfying level, slowly turn the thermostat clockwise and the room temperature thus
can keep constant.
•
If you want to change the room temperature, you can make another regulation: turn the thermostat clockwise to arise
the temperature and counterclockwise to lower it.
•
After use, turn the thermostat to the min position and unplug from power supply.
NOTES:
•
The room must be closed, if not, using of fan heater will not make good result because of heat leakage.
CLEAN
AND
CARE
•
Unplug from the power supply and allow the appliance to cool down.
•
Wipe out with a soft damp cloth. Do not use detergent or abrasives.
•
Do not scrap the surfaces of fins with sharp hard tools, to avoid surfaces getting rusty, because of damage of the paint
coat.
STORAGE
•
Switch off and unplug the appliance. Ensure the heater is completely cool.
•
Complete all requirements of chapter CLEAN AND CARE.
•
Reel on the power cord.
•
Keep the appliance in a dry cool place.
