Обогреватели Hyundai H-HO-23-09-UI3358 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
IM2021
14
3. Install wheel plates on the lower part of radiator sections using U-shaped brackets and
finger nuts, into two fixed supports.
4. Tighten two finger nuts on one side and two finger nuts on the other
– in clamp
extensions passed through the wheel plate supports, after making sure that 2 openings in
the wheel plate match together with the clamp extensions.
5. Turn the radiator back on the wheels.
Fig. 2
Fig. 3
IMPORTANT!
1. Switch on and operate the radiator only when it is in vertical position (with wheels below and
control elements above). Any other position may cause a dangerous situation and result in
failure of the oil-filled radiator or damage of property. The manufacturer will consider this as a
non-warranty case.
2. Do not switch the radiator on, if roller wheels are not installed.
8. OPERATION OF THE DEVICE
1. Before starting to use the device read section «Safeguards».
2. Connect the unit’s power cord to an electric outlet, observing all of the mentioned precautions.
Remember that you can connect the unit to electric mains only if the power mode knob is in
«OFF» position, which means the knob should be rotated against the stop counterclockwise.
3. It is also preferable to turn the thermostat knob against the stop counterclockwise. Then you
can connect the unit to electric outlet.
4. Set the unit’s power mode knob to position “1”, “2” or “3” (low, medium and maximum heating
power respectively). Remember that the higher heating power you choose, the faster the unit
heats the air. But at a low power you save electric power and reduce the load on your electric
mains.
5. After you chose heating power, you need to choose heating temperature. Turning the
thermostat knob clockwise (from MIN position to MAX position), you adjust the temperature you
need. After you choose the temperature (and after you chose heating power mode, see 4.) the
oil-filled radiator will start to heat.
6. During the first minutes of radiator’s operation you may fell a slight smell of burning. It may be
caused by dust on the unit; it will soon disappear. If necessary, you can clean the unit, following
rules in this manual and observing «Safeguards».
