Hyundai H-HG1-42-UI578 - Инструкция по эксплуатации - Страница 10

9.

Gas ceramic heater

EN

1. Gas heater installed on lat surfaces

2. Heat ceramic radiator heater is situated to the back of the gas bag and is not directed at him
3. Gas hose conducted with rear heater

IMPORTANT! 

Do not start the gas-ired ceramic heater in rooms having volume less 

than 84 m3. 
The minimum area of a vent should be at least 105 cm2. 
Necessary air exchange 10m3 / hour der 1 kW of thermal power heater.

IMPORTANT! 

Never use a gas ceramic heater without attached supporting legs

5. OPERATION

During  operation,  the  gas-ired  heater  burns  oxygen  contained  in  air  and  emits  carbon  dioxide 

(CO2). 

It is important to remember that operation of the gas-ired ceramic heater is permitted only in well 

ventilated rooms. This allows keeping the necessary concentration of oxygen in air and removing 
combustion products. 
Operation of the heater in closed and poorly ventilated rooms may create an asphyxiating atmo-
sphere and cause a lack of oxygen. If the oxygen concentration decreases below 18%, the ODS sys-

tem (oxygen detector) activates and switches the heater of. In this case it is necessary to ventilate 

the room before restarting the heating mode.

Connecting the gas heater

1. Check for proper assembly and installation of the gas heater, and the accession gas tank in-
structions below
2. Gently remove the valve gas cylinder and check for gas leaks with soapy water. The formation of 
bubbles indicates the presence of a gas leak in the wiring. In this case, replace the valve of the gas 

container, immediately contact an authorized service center Hyundai to ix this problem

3. Turn the gas valve of heater counterclockwise until it stops at maximum power and push it in. 
4. Fast light radiating heater on the obverse ceramic panel with the ignition matches or lighters 

(Attention! there is a risk of ire, be extremely careful.

Hold the gas valve in the clamped position for 10 seconds. If the burner goes out, wait 5-10 min-
utes and repeat the above steps again.
5. To adjust the power level, heating and/or installation minimum power turn the gas valve to the 
heater clockwise.