FRICO SWH02 - Инструкция по эксплуатации - Страница 24

SWH

23

GB  

General Instructions

Read these instructions carefully before 
installation and use. Keep this manual for 
future reference.

The product may only be used as set out in 
the assembly and operating instructions. 
The guarantee is only valid if the product 
is used in the manner intended and in 
accordance with the instructions.

Application

SWH belongs to a new generation of 
intelligent fan heaters with SIRe integrated 
controls. SWH and SIRe together can provide 
fully automatic room heating, adaptable to 
each area of use.
SWH is suitable for use in premises where 
fan heaters are traditionally used, such as 
industrial buildings, as well as environments 
with low sound requirements.
Protection class: IPX4.     

The unit consists of the following:

Corrosion-proof, hot rolled galvanized and
powder coated casing. Colour code: RAL9016,
NCS 0500. Top/bottom lids are easy to open 
and are fitted with hinges for easy and simple 
installation and maintenance.

Fully enclosed single-phase 230V, 50Hz, 
intergrated motor with an axial fan. 
Protection class IP44. Maximum surrounding 
temperature: +40 °C.
 
The motor is equipped with an automatically 
returning thermocontact which is connected 
to the terminal blocks.

Heating coil with aluminium fins (fin 
distance 2 mm) and copper tubes. Smooth 
pipe connections for soldering or clamping 
ring coupling.  In standard designs, SWH is 
intended for hot water up +125 °C and 10 bar. 

All models are delivered with individually 
adjustable louvres for controlling the air 
current in one direction. Louvres of anodized 
aluminium.

Mounting

The unit is delivered with casing, fan, heating 
coil and air director as standard. Mounting 
brackets are orded separately. 

Can be mounted on the wall for horisontal 

air distribution or on the ceiling for vertical 
air distribution. By turning the fan heater, 
pipe connections are possible on both sides. 

Mounting without accessories

Measure and mark the drilling holes on the 
wall or on the celing. Use a suitable screwing 
device to fit the brackets. Use the included set 
of screws to fit the brackets on to the unit.

Mounting with mixing cabinet SWBS and filter 
section SWF

The mixing cabinet and/or the filter section 
are mounted together with the unit with 
screws or guides.

The damper motor is fitted to the damper 

shaft. If required, the damper motor can be 
mounted on the opposite side of the mixing 
cabinet by loosening the screws holding the 
shaft. These screws can be reached from the 
inside of the mixing cabinet.

When the filter section is used with the 

unit only and mounted on to the wall, use 
the return air intake SWD. The return air 
intake is mounted together with the SW unit 
with screws or guides. The return air intake 
is mounted on to the wall with a suitable 
screwing device. 

When the mixing cabinet is fitted with a 

return air duct, remove the three screws 
holding the circular protection grill and install 
a circular duct on to the mixing cabinet. 
The construction should bee stabilized by 
pendlums, rods, straps or similar from the 
wall or the ceiling. 

Check the connections between the units, 

in case of air leakage use a suitable strip seal. 
All casings of the accessories are laquered on 
delivery.

Mounting of the basic filter SWFTN

The unit can be provided with a basic filter 
to protect the heating coil (not included on 
delivery). The top/bottom lid is opened, and 

Assembly and operating instructions