Обогреватели FRICO HP 305 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
Thermocassette HP
10
GB
4. Hook the panel brackets to the ones on the
ceiling (only the side nearest to the cable
gland). Allow panel to hang vertical. (ig.
3B)
5. Connect the panel.
6. Swing up the panel, and adjust the lateral
position of the ceiling mounted brackets.
(ig. 3C)
7. Swing down the panel and tighten the
screws in the ceiling. (ig. 3D)
8. Swing up the panel again and hook the
panel bracket ends in the ceiling brackets.
NOTE! Make sure that the brackets do not
become unhooked at the other end.
9. Secure the panel with a screw (enclosed
on delivery) at each hanging point. (ig.
3E)
10.The second last page in this mounting
instruction is to be illed out and ixed
adjacent to the distribution board and it
has to contain (drawing) the locations of
the heating units.
Replacement of cable for HP305 or HP605
1. Because of limitations in the IP55 category
the cable cannot be changed.
2. If the cable is damaged the unit has to be
scrapped.
Accessories
T10, electronic thermostat
Can control the heat directly or via contactor
when larger loads need to be controlled.
Internal temperature setting +5 to +35
o
C. .
Required connection voltage: 230V. IP30.
TK10
is equipped with an external dial for
setting the temperature.
KRT1900, capillary tube thermostat
Internal temperature setting 0 to +40
o
C.
Required connection voltage 230/400V (volt
free contact). IP55.
ERP, electric heating regulator
ERP is a modern, variable regulator that
adapts the energy use exactly to the demand
and allows for full use of the advantages with
radiant heating. The result is a warm heat and
more energy eficient use. For use on 230V
and 400V2~ (not 3-phase loads).
Load: 3600/6400 W. IP20.
Slave unit
ERPS
can be used with larger
outputs (ERPS handles the same outputs as
ERP).
CIRT, variable output regulator with timer
Especially suited for spot and zone heating.
The heat contribution is regulated for best
comfort (25-100%). Built-in timer that can
be set on 1/2-4 hours alt. 4-24 hours in
the standard setting. For use on 230V and
400V2~ (not 3-phase loads). Load: 3500/6000
W. IP44.
More alternatives are available in the Frico
assortment.
For illustrations see page 5.
