FRICO EZ336 - Инструкция по эксплуатации - Страница 15

Elztrip EZ 300

14

GB  

General Instructions

Read these instructions carefully before 
installation and use. Keep this manual for 
future reference.

The guarantee is only valid if the units 
are used in the manner intended by the 
manufacturer and in accordance with the 
Frico mounting and operating instructions.

Application area

Elztrip EZ300 has three heating panels and is 
designed for ceiling heights between 4 and 12 
metres. 

EZ300 is used in shops, department stores, 

exhibition halls, warehouses etc. EZ300 can 
be used both for total and supplementary 
heating. EZ300 is also suited for spot heating 
of parts of the premises. 
Protection class: splash-proof design (IP44).

Operation 

The panels have an operating temperature of 
up to 350 °C and the heat is radiated to cold 
surfaces. Heating with radiant heaters is very 
energy eficient and a high comfort level is 
obtained. Max. surrounding temperature is 
+30 °C. 

Mounting 

Elztrip EZ300 is mounted on the ceiling, on 
armature rails, wire or suspended from the 
ceiling by means of rods or chains. The units 
are intended for permanent installation and 
should always be mounted horizontally. 

In rooms frequently used, the heater should 

be mounted 1.5 to 2 metres above head 
height, see Fig. 2. The distance between the 
panels should not be more than the height 
between panel and loor, i.e ”a” should be less 
than ”H”, see Fig. 2. For minimum mounting 
distance, see Fig. 3.  

Standard ittings (2 pcs) for mounting are 

included and are found inside the connection 
box.

1  Determine the position of the panel on the 

ceiling.

2  Bend the "legs" of the brackets (ig 1.1) 

approximately 90° (ig 1.2). 

3  Mount the brackets with an internal 

distance according to dimensional drawing 
page 2, on the ceiling or on a wire (ig 1.3). 
When the panel is mounted on a wire put 
the bracket on top of wire. Mount the panel 
according to ig 1.4, start with one end 
and then assemble the other one. Make 
sure that the screws are tightened. When 
mounting on wire, use clips that prevent 
the panel from sliding.

Electrical installation

EZ300 is delivered prewired for 400 V3N~ 
and permanent installation, can be converted 
for 230 V3~. The heater(s) should only be 
wired by a competent electrician, and in 
accordance with existing national regulations. 
The appliance should be preceded by a double 
pole switch with at least 3 mm breaking 
gap. There are two holes with cable glands 
Ø32,5 mm on the top of the connection box. 
The cable glands used must guarantee the 
protection class requirements. Connection 
and serial connection are done via the block 
terminals (16 mm²).

Maintenance

There might be a rattling noise the irst time 
of use when the surface coating of the panels 
is settling. 

If the heater is used in rooms where there 

are aerosols, lacquer, solvents and similar, 
this can cause a coating on the panels and 
discolour them. The output is not affected. 

Mounting and operating instructions