FRICO AR210E09 - Инструкция по эксплуатации - Страница 24

23

GB  

AR 20 0 A/E/W

Changing the electric coil/battery 
(AR200E)

1. Mark and disconnect the cables to the 

electric coil/battery.

2. Remove the mounting screws securing 

the electric coil/battery in the unit 
and lift the electric coil/battery out.

3. Install the new electric coil/battery in 

reverse order to the above.

Replacing the electric heater/coil 
(AR200E)

1.  Mark and disconnect the cables to 

the electric heater/coil.

2.  Remove the mounting screws 

securing the electric heater/coil in 
the unit and lift the electric heater/
coil out.

3.  Install the new electric heater/coil in 

reverse order to the above.

Trouble shooting

If the fans are not working or do not 
blow properly, check the following:

•

.  Operating power supply to the unit; 

check fuses, circuit-breaker, time 
switch/thermostat (if any) that starts 
and stops the unit.

•

.  That the air flow selector is correctly 

set.

•

.  That the position limit switch is 

working.

•

.  That the overheat protection for the 

motors has not been deployed.

•

.  That the intake grille is not dirty.

If there is no heat, check the 

following:

•

.  That the heat demand exists; check 

thermostat settings and actual 
temperature.

For units with electrical heating, check 
the following:

•

.  Power supply to electric heater coil; 

check fuses and circuit-breaker (if 
any).

•

.  That the overheat protection for the 

motors has not been deployed.

For units with water coil, check the 
following:

•

.  That the water coil is air free. 

•

.  That there is enough water flow. 

•

.  That incoming water is heated 

enough. 

If the fault cannot be rectified, please 
contact a qualified service technician.

Safety cut-out

(applies to units with electric heater)

If the installation is protected by 
means of a safety cut-out, which trips 
when the appliance is connected, this 
may be due to moisture in the heating 
element. When an appliance containing 
a heater element has not been used 
for a long period or stored in a damp 
environment, moisture can enter the 
element.
This should not be seen as a fault, but 
is simply rectified by connecting the 
appliance to the mains supply via a 
socket without a safety cut-out, so that 
the moisture can be eliminated from 
the element. The drying time can vary 
from a few hours to a few days. As a 
preventive measure, the unit should 
occasionally be run for a short time 
when it is not being used for extended 
periods of time.