FRICO ADCS22E - Инструкция по эксплуатации - Страница 27

Thermozone AD  Corinte A/E  - ADCS

26

GB

curtain. The ventilation should therefore be 
balanced.

Vertical mounting

The unit is mounted vertically on the floor 
with the exhaust opening facing outwards.

Before installation, decide whether any 

electrical connections are to be made from 
below.

Do not remove the protecting plastic until 

mounting is completed. Be careful so the 
surfaces are not damaged. 
For installation see figure 3.
1. Undo the screws in the front panel.
2. Undo the screws that secure the front panel 

to the exhaust grille.

3-4. Take off the front panel.
5. Place the edge on the floor and if necessary 

secure it using expander bolts or similar in 
the countersunk holes (see fig. 5). Stand the 
air curtain on the edging.

6. Flat bar for fixing of the air curtain is 

supplied. Fix the air curtain through the 
quadratic hole, to secure it sideways. Make 
sure that the flat bar is not bent when 
securing.

7. Secure the top with an angle bracket or 

similar to prevent the air curtain from 
toppling over. There is a hole in the centre 
of the top of the air curtain with an internal 
M6 thread for securing the bracket.

  Please observe that the unit can not be 

turned because the overhetating protector 
is placed at the top.

Horizontal mounting

The unit is mounted with the outlet facing 
downwards. Do not remove the protective 
plastic until mounting is completed. Take care 
not to damage the surfaces.

For optimal performance it is recommended 

that a minimum gap of 220 mm to the ceiling 
is maintained above the air curtain. Closer 
mounting might cause over heating.

Two brackets are delivered with the unit 

for mounting on the wall or hanging from the 
ceiling.

General instructions

Read these instructions carefully before in-
stallation and use. Keep this manual for future 
reference.

The guarantee is only valid if the Thermo-
zone units are used in the manner intended 
by the manufacturer and in accordance with 
the Frico installation and maintenance in-
structions.

Application area

AD Corinte belongs to a new generation of 
intelligent air curtains with SIRe integrated 
controls, together they can provide fully auto-
matic protection for the entrance, adaptable 
to each area of use.

AD Corinte is intended for exclusive shop 
entrances and other environments with high 
demands in respect of design and soundlevel. 
Mounted with one unit on either side of the 
opening, thus creating a classic symmetry, the 
curtain effect and comfort is optimized.

The Thermozone AD Corinte air curtain is 
supplied with or without an electric heater 
coil and is intended for permanent installa-
tion above or beside entrance doors and other 
openings up to 3 metres in height.
Protection class IP20

Operation

Air is drawn in at the top/rear of the unit and 
blown out downwards/outwards so that it 
shields the door opening and minimizes heat 
loss. To achieve the optimum curtain effect 
the unit must extend the full height/width of 
the door opening.

During installation the exhaust grille is 

normally directed outwards slightly so that 
the airflow obstructs incoming cold air. (See 
fig 1).

The fan speed should be controlled using a 

frequency converter.

The efficiency of the air curtain(s) depends 

on the air temperature, pressure differences 
across the doorway and any wind pressure. 
NOTE! Negative pressure in the building 
considerably reduces the efficiency of the air 

Assembly and operating instructions