BRAYER BR4805 - Инструкция по эксплуатации - Страница 9

9

EN

Fan heater oscillation mode

• 

Press the button (11) «

» on the control panel (3) 

or the button (15) «

» on the remote control (17) to 

switch the body oscillation mode on, the symbol «

» will appear in the operation mode icons row (9). To 

switch the oscillation mode off, press the button (11) 

«

» or (15) «

» again, the symbol «

» on the 

control panel (3) will go out.

Timer setting

• 

Press the timer on/off button (8) «

» on the control 

panel (3) or the button (14) «

» on the remote control 

(17) and set the requited timer operation time.

•  Time setting range is up to 12 hours.

•  The timer operation time is indicated with the digital 

symbols (10) on the control panel (3). 

• 

To switch the timer off, consequently press the button 

(8, 14) «

» until the digital symbols (10) show the 

room temperature.

Room heating temperature setting
ATTENTION!

 You can set the room heating temperature 

only with the remote control (17).
• 

Press the buttons (16) «

» on the remote control 

(17) to set the required room heating temperature.

•  The temperature setting range is from 15 to 47 

degrees, the temperature is displayed on the control 

panel (3) with digital symbols (10).

• 

Switching the fan heater off

• 

Switch the fan heater off by pressing the on/off button 

(6) «

» on the control panel (3) or the button 

(12) «

» on the remote control (17).

• 

Note: 

— after pressing the buttons (6, 12), the 

heating element will switch off, but the fan will 

continue to operate for 30 seconds to cool the 

heating element.

• 

After the fan stops, switch the power off by setting 

the switch (5) to the position «0».

AUTOMATIC EMERGENCY SWITCH-OFF 

FUNCTION IF THE OUTGOING AIR IS TOO 

HOT

•  If the outgoing air temperature exceeds the 

acceptable value, the automatic thermal switch will 

switch on, and the fan heater will be switched off.

•  Set the power switch (5) to the position «0» and 

unplug the unit, let the fan heater cool down for 

approximately 15-25 minutes (depending on the air 

temperature in the room) and only after that you can 

switch the unit on again.

• 

Make sure that the front (2) and rear grids  are not 

blocked with foreign objects.

• 

Insert the power plug into the mains socket and 

switch the fan heater on.

• 

If the fan heater does not switch on, it may be caused 

by another malfunction. In this case apply to a 

service center for repairing of the fan heater.