BRAYER BR4801 - Инструкция по эксплуатации - Страница 7

7

EN

turn the thermostat control knob (7) counterclockwise 

until you hear a distinctive click; in this position the 

thermostat will maintain the set air temperature in the 

room automatically.

•  To increase the air temperature in the room, turn 

the thermostat control knob (7) clockwise and 

counterclockwise to decrease it.

• 

Note:

 — the fan heater will not switch on if the 

thermostat settings correspond to the air temperature 

in the room.

• 

After the unit operation is finished, turn the 

thermostat control knob (7) counterclockwise as far 

as it will go «-» and set the operation mode switch (6) 

to the position «OFF» and unplug the unit.

• 

Note: 

— when you switch the unit on for the first 

time, some smoke or foreign odor may appear. It is 

normal and not covered by warranty.

AUTOMATIC EMERGENCY SWITCH-OFF 

FUNCTION IF THE OUTGOING AIR IS TOO 

HOT

•  If the outgoing air temperature exceeds the 

acceptable value, the automatic thermal switch will 

switch on, and the fan heater will be switched off.

•  Set the operation mode switch (6) to the position 

«OFF» and unplug the unit, let the fan heater cool 

down for approximately 15-25 minutes (depending on 

the air temperature in the room) and only after that 

you can switch the unit on again.

•  Make sure that the front (2) and rear grids (5) are not 

blocked with foreign objects.

•  Insert the power plug into the mains socket and 

switch the fan heater on.

•  If the fan heater does not switch on, it may be caused 

by another malfunction. In this case apply to a 

service center for repairing of the fan heater.

PROTECTION FROM DROPPING

•  If the fan heater accidentally falls or tilts too much, 

the fall protection device will switch on and the fan 

heater will be switched off.

•  Set the fan heater into vertical position, and the unit 

will resume operation.

• 

Note: 

— place the fan-heater on a flat dry and steady 

surface to prevent it from dropping.

CLEANING AND  MAINTENANCE

•  Before cleaning the fan heater set the operation 

mode switch (6) to the position «OFF», and make 

sure that the power plug is not inserted into the 

mains socket.

•  Wipe the fan heater body with a slightly damp cloth 

and then wipe it dry.

•  Do not use liquid detergents, abrasive cleaners and 

any solvents to clean the fan heater.

•  To avoid the risk of electric shock provide that no 

water or other liquid gets into the fan heater body.