Обогреватели BRAYER 1500 Вт BR4851 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
9
EN
Fan heater oscillation mode
•
Press the button (11) «
» on the control panel (3)
or the button (15) «
» on the remote control (17) to
switch the body oscillation mode on, the symbol «
» will appear on the control panel (3). To switch the
oscillation mode off, press the button (9) «
» again,
the symbol « » on the control panel (3) will go out.
Timer setting
•
Press the timer on/off button (7) «
» on the control
panel (3) or the button (14) «
» on the remote control
(13) and set the requited timer operation time.
•
Time setting range is up to 12 hours.
• The timer operation time is indicated with the digital
symbols (10) on the control panel (3).
•
To switch the timer off, consequently press the button
(7,14) « » until the digital symbols (10) show the
room temperature.
Room heating temperature setting
ATTENTION!
You can set the room heating temperature
only with the remote control (17).
•
Press the buttons (16) «
» on the remote control
(17) to set the required room heating temperature.
•
The temperature setting range is from 15 to 47
degrees, the temperature is displayed on the control
panel (3) with digital symbols (10).
•
Switching the fan heater off
•
Switch the fan heater off by pressing the on/off button
(6) «
» on the control panel (3) or the button
(12) «
» on the remote control (17).
•
Note:
— after pressing the buttons (6,12), the
heating element will switch off, but the fan will
continue to operate for 30 seconds to cool the
heating element.
•
After the fan stops, switch the power off by setting
the switch (5) to the position «0».
AUTOMATIC EMERGENCY SWITCH-OFF
FUNCTION IF THE OUTGOING AIR IS TOO
HOT
•
If the outgoing air temperature exceeds the
acceptable value, the automatic thermal switch will
switch on, and the fan heater will be switched off.
•
Set the power switch (5) to the position «0» and
unplug the unit, let the fan heater cool down for
approximately 15-25 minutes (depending on the air
temperature in the room) and only after that you can
switch the unit on again.
•
Make sure that the front (2) and rear grids are not
blocked with foreign objects.
•
Insert the power plug into the mains socket and
switch the fan heater on.
•
If the fan heater does not switch on, it may be caused
by another malfunction. In this case apply to a
service center for repairing of the fan heater.
