Ardesto CHH-2000MWC - Инструкция по эксплуатации - Страница 10

EN

10

SAFETY REQUIREMENTS 

Before connecting the convector to the power supply, be 

sure to visually check the power cord and the convector 

for mechanical damage. If there are damages, contact an 

authorized service center for repair. Before repairing damage, it 

is not allowed to connect the convector to the power supply. 

Disconnect the convector from the power supply during its 

maintenance, wet cleaning of the room near the convector 

installed on the floor. 

Disconnect the electric convector from the power supply by 

holding the plug of the power cord. 

Do not use this heater near bathtubs, showers or

swimming pools.

Do not use the device in rooms with high humidity.

Place the device at a distance of not less than 1.5 meters from 

open flame.

Provide that no water gets on the device body.

If any water gets on the device body, unplug the device before 

touching it and only then wipe water drops.

Always use the supporting legs when placing the device and 

place the device on a flat steady surface. Before using the 

device make sure that the legs are installed properly.

Do not use the device in the rooms where inflammable 

substances are kept or used.

Do not use the device, if the room temperature is over +30°C.

Do not leave the switched on device when sleepingand do not 

place it near a sleeping person.

Do not allow paper or foreign objects inside the convector. 

Do not use the convector for other purposes (the convector is 

not intended for outdoor use). 

Do not operate the convector with damaged power cord. 

Make sure that the power cord does not not touch sharp 

corners and heated surfaces of the convector.