Ardesto CHB-2000MBD - Инструкция по эксплуатации - Страница 17

EN

17

BEFORE THE FIRST USE

After device transportation or storage at low temperature keep it for at least 

three hours at room temperature. 

• 

Unpack the device. 

• 

Check the device for damages, do not use it in case of damages. 

• 

Make sure that the device operating voltage corresponds to the voltage 

of your mains. 

• 

Make sure that the operation mode switch (4) is set to the position «0» 

(the device is switched off ). 

SET TING 

Stand mode 

• 

Turn the device over. 

• 

Insert the supporting plates with wheels (1) into the openings on the 

convection fan heater body. 

• 

Turn the device over and set it on the wheels. 

USING THE  CONVECTOR 

• 

Before switching the device on, make sure that your home mains voltage 

corresponds to the device operating voltage, and the switch (4) is in the 

position «0» (the device is switched off ). 

• 

Insert the power plug into the mains socket. 

• 

Set the operation mode switch (4) into the necessary position: 

–  0 – the fan heater is switched off, 

–  I – minimum heating power (1000 W ), 

–  II – maximum heating power (2000 W ). 

To dry small items, install the bracket (3) on the convector body (5). 

Note:

 do not hang wet clothes, large towels etc. on the bracket (3).

To use the natural humidification function, install the water tank (6) on the 

convector body (5).

Notes:

• 

Do not install the water tank (6) if you do not plan to use this function.

• 

Pour water into the water tank (6) only when it is installed on the device 

body (5), the convector is switched off and the power cord is unplugged.