SVEN E-705BT - Инструкция по эксплуатации - Страница 16

ENG

16

Wireless Stereo Headphones

with Microphone

Headset to a device interfacing

•

 It is necessary first to interconnect the device with a signal source 

(see the connection diagram in Fig. 2) to transfer signals via Bluetooth. 

To pair the headphones with the device, put them to the charging case, 

then get them out. Both earphones are automatically switched on and 

connected to each other. At the same time on the right earphone LED 

indicator 

b

 will alternate blue and red glow, and indicator 

b

 on the left 

earphone will light blue. 

•

  It is necessary to select Bluetooth device search mode on a signal 

source (telephone, notebook, smartphone, etc.). «SVEN E-705BT», 

massage will be displayed on the screen, which is to be connected to*.

•

  If connection successful, there will be a short beep signal in the 

headphones; the search mode indication on the headphones is over. If 

no devices connected, headphones will turned off automatically in 2 

minutes.

•

  If you cannot connect your device or connect a headset to each 

other, or the sound is played from only one earphone, you must 

re-enter the system to the search mode. Put the headphones to the 

charging case (headphone indicators 

b

 turn red), press and hold the 

multi-function button 

a

 for 8 seconds, until the light indicator 

b

  on 

the right earphone does not blink blue 4 times and then lights up in red. 

Take headphones out the caseand they will automatically connect to 

each other. After that, pair the headphones with the device, as 

described above**.

*  You might have to enter “0000” code to connect some models of 

devices via Bluetooth.

** If the item has been already registered to the source device list, then 

the second search mode activation is not obligatory. Choose only the 

item name «SVEN E-705BT» and the “connect” command on the 

source.