SVEN AP-B545MV - Инструкция по эксплуатации - Страница 14

ENG

14

Wireless Stereo Headphones

with Microphone

6. CONNECTION AND OPERATION

Attention! The built-in battery must be charged completely prior to the headphones 

application.

Headset charging

• 

Connect the headphones to a USB port of PC or USB charger using USB/micro USB cable 

(included). During battery charging the indicator 

f

 is red.  

• 

When the device is charged in full, the indicator 

f

 goes out.

• 

After fully charging you should get around 10 hours playtime before you need to recharge 

the headphones, always try to avoid letting them go totally flat to deter internal battery damage.

• 

The battery in the headphones is used as an integral part of the device, therefore do not 

try to extract or replace it, because this can result in the warranty cancellation or the device 

damage.

Bluetooth mode

• 

Press and hold the Multi-function button 

b

, to turn on the headphones and enter 

Bluetooth pairing mode, this is indicated 

h

 by an alternating flashing red and blue LED. 

Open your device’s Bluetooth mode and search for the pairing name «SVEN AP-B545MV» 

and select. If your device asks you for a pairing code enter “0000”. Once paired successfully 

a tone can be heard and the LED indicator 

h

 on the headphones will flash blue intermittently.

• 

Use the earcup control buttons  (

b

, 

c

 and 

d

) to play, pause or navigate up and down 

your tracklist. Press button 

b

 to play and pause the current track, short press button 

c

 for 

volume up or button 

d

 for volume down and long press button 

c

 for next track or button 

d

 for previous track.

TF/MP3 mode

• 

With the headphones on insert a compatible TF (micro SD) card in the slot on the earcup  

a

 and they will automatically switch to MP3 mode and begin playing the first compatible 

track. Alternatively press the mode button 

e

 repeatedly until the headphones enter MP3 

mode. Use the earcup control buttons (

b

, 

c

 and 

d

) to play, pause or navigate up and 

down your track list as described above.

FM radio mode

• 

With the headphones on press the mode button 

e

, repeatedly until you enter FM mode. 

Next press and hold the Mode button 

e

 again for around 3-4 seconds to begin the channel 

scan and store feature. Once completed you can move up and down the stored stations 

using the next track 

c

 and previous track 

d

 buttons. To increase or decrease the volume 

level press and hold buttons  

c

 and 

d

 as described above.

AUX  mode 

• 

Use the 3.5mm cable provided to connect your headphones to any compatible audio 

source. The headphones don’t even need to be switched on, but the track control and 

volume buttons wont work and must be controlled at source using this method. 

Device switching on/off

• 

 In order to turn on the headphones press and hold the button 

b

 before you hear a beep 

signal. When the device is turned on, the LED indicator 

h

 will start blinking. In order to turn off 

the device, press once more and hold the button

b

, before you hear a beep signal.