TWS Anker Soundcore Life Dot 2 NC - Инструкция по эксплуатации - Страница 6

EN    04

When  you’re  wearing  the  earbuds,  they  will  not  power  off  until  out  of  battery.  When 
you  remove  the  earbuds,  they  will  automatically  power  off  after  30  minutes  if  no 
device is connected.   

Bluetooth Pairing

1. Open the charging case, the earbuds will automatically enter the Bluetooth pairing 

mode.

  The  LED  indicator  on  one  earbud  will  flash  quickly  and  on  another  earbud 

breathe slowly.

2. Select 

“Soundcore Life Dot 2 NC”

 on your device’s Bluetooth list to connect.

  When  successfully  connected,  the  LED  indicator  on  earbuds  will  light  up  white 

for 1 second and then turn off.

2

Soundcore 

Life Dot 2 NC

Soundcore 

Life Dot 2 NC

1

• 

Each time you power on your Soundcore earbuds, they will automatically connect 
to your last successfully connected device if available within the Bluetooth range.

•  Mono mode:

 When Bluetooth connected, you can use either one of the earbuds 

only by placing the other one into the charging case and closing it.

• 

When  powered  on  and  connected,  if  either  one  of  the  earbuds  is  out  of  battery 
and powered off, you can keep using the other one.

• 

When  you  are  on  a  call,  place  either  one  of  the  earbuds  into  the  charging  case 
and close it, the microphone in the other earbud will be activated.

• 

The  right  earbud  is  the  primary  earbud  by  default.  If  you  want  to  change  this, 
remove  the  right  earbud  from  your  ear  and  leave  the  charging  case  open,  the 
microphone  in  the  other  earbud  will  be  activated.  Place  the  right  earbud  in  the 
charging case and close it, the left earbud will become the primary earbud.