FIRST AUSTRIA FA-2419-3 - Инструкция по эксплуатации - Страница 3

4

5

Press the memory/memory+ button; “P01” will blink in the display. 

Press the memory/memory+ button again to set the preset. 

Repeat steps 2 through 4 to set more presets. 

The unit can preset 10 stations totally for FM.

When “P01-P10” is blinking, press the Tune+ or Tune- button to select the preset 

number. 

When recalling preset stations, press memory/memory+ to select the preset 

number. 

SLEEP OPERATION

When listening to radio, press Snooze/Sleep button (4) to enter sleep mode. You 

can just adjust the sleep timer from 90mins to 15mins by pressing the Snooze/

Sleep button (4). The unit will automatically turn off after the selected time. 

NAP TIMER FUNCTION (COUNT DOWN TIMER)

During radio off mode, press MEMORY.SET/MEMORY+/DISPLAY LIGHT 

AUTO ON/OFF/NAP button (1) to turn on NAP mode, the NAP time will keep 

by 5 seconds, within 5 seconds and press MEMORY.SET/MEMORY+/DISPLAY 

LIGHT AUTO ON/OFF/NAP button (1) button can change the duration from 

90min-10min. 

The alarm buzzer will sound for 30min and then shut off automatically. To stop 

the alarm buzzer, press the ON/OFF button (9). 
Press the MEMORY.SET/MEMORY+/DISPLAY LIGHT AUTO ON/OFF/NAP 

button (1) has no effect during alram operation. Press ON/OFF button (9) to 

cancel NAP function. 

WARNING

1.  No naked flame sources, such as lighted candles, should be placed on the 

apparatus. 

2.  Do not place the product in closed bookcases or racks without proper 

ventilation.

3.  Where the mains plug is used as the disconnect device, the disconnect 

device shall remain readily operable. 

4.  The ventilation should not be impeded by covering the ventilation openings 

with items, such as newspapers, table-cloths, curtains, etc.

5.  It shall not be exposed to dripping or splashing and that no objects filled with 

liquids, such as vases, shall be placed on the apparatus. 

6.  Do not connect FM antenna to outside antenna. 

7.  The unit should not be exposed to direct sunlight, very high or low 

temperature, moisture, vibrations or placed in dusty environment.

8.  Do not use abrasive, benzene, thinner or other solvents to clean the surface 

of the unit. To clean, wipe it will mild non-abrasive detergent solution and 

clean soft cloth. 

9.  Never attempt to insert wires, pins or other such objects into the vents or 

opening of the unit. 

10. Disconnect device warning: Mains plug is used as the connection, so it 

should always remain ready operate. 

11. Batteries shall not be exposed to excessive heat such as sunshine, fire or the 

like.

CAUTION

Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type.

ENGLISH

ENGLISH

SPECIFICATIONS 

Frequency range:  

FM 87.5-108MHz 

Battery backup:  

 3V (1x3V CR2032 Flat Lithium battery) 

(Not included)

Power source: 

AC 230V ~ 50Hz 

Operation Temperature:  0°C - + 50°C  

RESETTING

If the system does not respond or exhibits erratic or intermittent operation, you 

may have experienced an electrostatic discharge (ESD) or a power surge that 

triggered the internal microcontroller to shut down automatically. If this occurs, 

simply disconnect the AC power cord and remove the system backup battery, 

wait for at least 3 minutes and then setup the unit again as if it is a brand new 

unit.

Environment friendly disposal

You can help protect the environment! Please remember to respect the local 

regulations: hand in the non-working electrical equipments to an appropriate 

waste disposal center.