Einhell GE-DP 7330 LL - Инструкция по эксплуатации - Страница 21

GB

- 21 -

Manual operation:

Mount the 

fl

 oating switch as illustrated in Fig. 1. 

The equipment will then run continuously. To pre-

vent dry running, this operating mode is allowed 

only under supervision. The equipment must be 

switched o

ff

  (pull out the power plug) as soon as 

no more water is emitted from the discharge line.

Dirty water mode (Fig. 4/5):

• 

 Turn the equipment counter-clockwise up as 

far as the stop (Fig. 4/5).

Shallow suction mode (Fig. 5):

• 

 Turn the equipment clockwise down as far as 

the stop (Fig. 5).

• 

 In shallow suction mode, water can be su-

cked up down to a level of 1 mm.

• 

 Only clean water can be sucked up in shallow 

suction mode.

Please note:

For the equipment to suck up water in shallow 

suction mode there must be a minimum depth of 

10 mm of water.

7.  Replacing the power cable

Danger!

If the power cable for this equip-

ment is damaged, it must be 

replaced by the manufacturer or 

its after-sales service or similarly 

trained personnel to avoid dan-

ger.

8.  Cleaning, maintenance and 

ordering of spare parts

Danger!

Always pull out the mains power plug before star-

ting any cleaning work.

8.1 Cleaning

• 

 Keep all safety devices, air vents and the 

motor housing free of dirt and dust as far as 

possible. Wipe the equipment with a clean 

cloth or blow it with compressed air at low 

pressure.

• 

 We recommend that you clean the device  

immediately each time you have finished 

using it.

• 

 Clean the equipment regularly with a moist 

cloth and some soft soap. Do not use 

cleaning agents  or solvents; these could at-

tack the plastic parts of the equipment. Ensu-

re that no water can seep into the device. The 

ingress of water into an electric tool increases 

the risk of an electric shock.

8.2 Cleaning the intake cage and pump 

housing (Fig. 5/6/7/8):

1.  Screw out the three screws (Fig. 6/Item B) 

counter-clockwise.

2.  Turn the equipment up as far as the stop (Fig. 

5). Note the position of the lug (Fig. 5/Item A) 

and remove the intake cage (Fig.7/Item 4).

3.  Clean the intake cage (Fig. 7/Item 4) and the 

pump impeller housing (Fig.7/Item C) with 

clean water.

4.  Assemble in reverse order.

5.  When assembled, the lug must be in the cor-

rect position (Fig. 8/Item A).

8.3 Maintenance

There are no parts inside the equipment which  

require additional maintenance.

8.4 Ordering replacement parts:

Please quote the following data when ordering 

replacement parts:

• 

 Type of machine

• 

 Article number of the machine

• 

 Identification number of the machine

• 

 Replacement part number of the part required

For our latest prices and information please go to 

www.isc-gmbh.info

Anl_GE_DP_7330LL_5220LL_SPK7.indb   21

Anl_GE_DP_7330LL_5220LL_SPK7.indb   21

23.07.15   11:19

23.07.15   11:19