Мясорубки Saturn ST-FP8090T - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
5
Place the desired cutting plate next
to the cutting blade, fitting
protrusions in the slot (fig.5).
Support or press the center of the
cutting plate with one finger then
screw the fixing ring tight with
another hand (fig.6). Do not over
tighten.
Place the hopper plate on the head
and fix it into position.
Locate the unit on a firm place.
The air passage at the bottom and
the side of the motor housing
should be kept free and not
blocked.
MINCING MEAT
Cut
all
foods
into
pieces
(Sinewless, boneless and fatless
meat
is
recommended,
approximate size :20 mm x 20 mm
x 60 mm) so that they fit easily
into the hopper opening.
Plug the unit on and switch ON/0/R
knob to " ON " position.
Feed foods into the hopper plate.
Use for it only the food pusher
(fig.7).
After use switch the unit off and
unplug it from the power supply.
REVERSE FUNCTION
Snake will be rotating in the
opposite direction, and the head
will get empty.
If it doesn't work, switch off the
unit and clean it.
◆
Plug the unit " ON" ,then switch
ON/0/R knob to " R " position.
MAKING KEBBE
RECIPE
STUFFING
Mutton
100g
Olive oil
1 tablespoon
Onion (cut finely)
1 tablespoon
Spices
to your taste
Salt
to your taste
Flour
1 tablespoon
1.
Mince mutton once or twice.
2.
Fry onion until brown and add
minced mutton, all spice, salt and
flour.
OUTER COVER
Lean meat
450g
Flour
150-200g
Spices
to your taste
Nutmeg (cut finely)
1
Powdered red pepper
to your taste
Pepper
to your taste
3.
Mince meat three times and mix all
ingredients together in a bowl.
More meat and less flour for outlet
cover create better consistency
and taste.
4.
Grind the mixture three times.
5.
Disassemble by reversing the steps
from 5-3 to remove the cutting
plate and cutting blade.
6.
Place kebbe attachments onto the
feed screw shaft together, fitting
protrusions in the slots (fig.8).
7.
Screw cap into place until tight. Do
not over tighten (fig.9).
8.
Make the cylindrical outlet cover
(fig.10).
