Kraft KF-MG1401PBL - Инструкция по эксплуатации - Страница 26

26

MEAT GRINDER

USER GUIDE

 ATTENTION! Do not wash the metal parts of the meat grinder in the dishwasher!

  ATTENTION!  Do  not  use  gasoline,  benzene,  thinners,  hot  water,  caustic  and 

abrasive cleaning agents, sharp metal or rough brushes, etc., so as not to damage 

the surface of the device. Do not use high pressure cleaners or steam cleaners, as 

penetrating moisture can cause electric shock.

STORAGE

When  changing  the  workflow, 

quick  cleaning  is  allowed.  It  will  fill 
the bowl or any container half with 
water.  Immerse  the  meat  grinder 
nozzle  (leg  or  whisk)  of  the  meat 
grinder in water and turn it on for a 
few seconds.

Store the device in a dry, clean, ventilated place away from heating devices and direct 

sunlight.  During  transportation  and  storage,  do  not  expose  the  device  to  mechanical 
influences that may damage the device and/or violate the integrity of the package. Keep 
the packaging of the device away from water and other liquids.

 ATTENTION! Keep the device out of the reach of children!

TROUBLESHOOTING

During  operation,  if  malfunctions  are  detected  that  the  consumer  cannot  eliminate 

on their own, it is necessary to contact the service workshop. But before contacting the 
repair service, read this section. This list includes the most common cases that are not 
the result of poor assembly quality or poor-quality materials used in this device.

 ATTENTION! Before troubleshooting, it is necessary to disconnect the device 

from the power supply. Troubleshooting that is not presented in this manual should 

be carried out only by a qualified and competent specialist.

Malfunction

Possible cause

Solution

The device does not turn on.

The device is not connected to the 
power supply.

Connect the device to the power 
supply.

The electrical outlet is faulty.

Plug the device into a working 
outlet.

When grinding products, a strong 
vibration of the device is felt.

The products are cut too large.

Cut the products smaller.

During the operation of the device, 
an extraneous smell appeared.

The device overheats during 
operation.

Reduce the time of continuous 
operation, increase the intervals 
between switching on the device.