Telefunken TF-MSM2.102 - Инструкция по эксплуатации - Страница 6

5

Instruction manual

6

USB/SD operation

Connecting USB/SD

• Insert a USB device into the USB port or

insert a memory card into the memory card 
slot. The unit will switch to USB or SD mode 
automatically. The unit will start reading the 
device.

• When the device and tracks on it are

detected, the display shows the currently 
playing track number and track playback time.

Playback operations

• During playback press 

button

to  pause  playback.  Press  this  button  again 
to resume playback.

• During playback press

/

 buttons to

go to previous or next track.

General USB notes

• This unit is equipped with a USB socket

that can read and play MP3 files stored on 
standard USB flash (compatible with USB 
version 2.0) up to 32 GB.

  Always switch off the unit or change 

mode to another one before removing a USB 
flash drive to prevent damage to your USB 
device.

Note:

 Although this product is fully 

compatible with USB 2.0 standard, a small 
percentage of USB flash drives might not be 
readable, due to those device manufacturers’ 
non-compliance with the full (official) USB 
standards.

• FAT/FAT32 file system are supported.

According to the USB 1.1/2.0

Standard, usage of a USB device with power 
current consumption exceeding 500 mA is not 
recommended without supplementary power 
supply.

Bluetooth operations

Bluetooth wireless playback

• This unit can wirelessly playback audio

from any device with Bluetooth A2DP 
function.

• The wireless range is approximately within

10 meters.

• Wireless audio streaming requires pairing

of a Bluetooth device (e.g. smartphone).

HOW TO PAIR YOUR DEVICE TO THIS 

UNIT:

• Make sure the Bluetooth function is

switched on in your device (e.g. smartphone, 
tablet).

• Switch on the unit and press

MODE/INPUT to select the Bluetooth mode.

• Once the Bluetooth pairing indicator

begins flashing, you will find the unit listed in 
the  Bluetooth  connections  list  of  your  device 
(as TF-MSM2.10

2

).

• If asked for a passcode, enter “0000”
• The initial setup is required only once

per device. To pair another device repeat the 
above steps.

Failure to use supplementary power for 
connected USB drives with power consumption 
exceeding this value as well as defective USB 
drives may cause mechanical or thermal 
changes of elements of this unit as well as 
failure of internal elements of the USB port. 
Such damages are not warranty cases.

Warning:

 use of external USB drives 

containing BIN files in root directory may cause 
malfunction of unit or damage to the software.