Tefal CY601832 Home Chef Smart Multicooker - Инструкция по эксплуатации - Страница 30

59

58

EN

Problem

Possible reasons

Solutions

Intense release of 

pressure from pressure 

limit valve

Faulty pressure control 

resulted in release of pressure.

Send to repair and 

maintenance department.

Pressure limit valve did not 

fall into place.

Carefully rotate/press the 

pressure limit valve to make 

it fall into place.

Continuous pressure 

release from float valve

Residue in the float valve.

Clean and remove the 

residue.

Float valve is stuck.

Stop the appliance and 

wait for the appliance to 

cool down. Then clean and 

wipe the float valve, before 

restarting the cooking. 

“E0” , “E1” displayed on 

digital screen

Send to repair and 

maintenance department.

“E2” displayed on digital 

screen.

The lid is not in the position 

defined for the selected 

cooking mode.

Please refer to the cooking 

table to check the right 

position of the lid for the 

program you have selected.

Lid switch sensor does not 

function.

Send to repair and 

maintenance department.

TECHNICAL TROUBLESHOOTING GUIDE

Problem

Possible reasons

Solutions

Unable to open lid

Unable to open because of 

pressure in the cooking pot.

Press and hold the pressure 

release button to remove the 

pressure inside the cooking pot.

Pressure in the pot is fully 

released but the float valve is 

stuck because it is too dirty, 

and therefore unable to fall.

a.  

Press and hold the pressure 

release button to remove 

the pressure inside the 

cooking pot. Then let the 

appliance cool down for 

at least 2 hours and then 

press the external part of 

the float valve – Fig. 23.

b.  

For next use, please clean 

and wipe the float valve.

Unable to close lid

Hot pot with steam inside. 

Wait for the pot to be cool.

The sealing gasket was not 

properly installed.

Install the sealing gasket 

properly.

The float valve is stuck 

because it is too dirty, and 

therefore unable to fall.

a.  

Press the external part of 

the float valve (when the 

lid is cold) – Fig. 23.

b.  

For next use, please clean 

and wipe the float valve.

Direction at which lid was 

closed is incorrect.

Close lid in the correct 

direction according to the 

instruction manual.

Food is uncooked.

Rice : water ratio is incorrect.

Use the required rice : water 

ratio.

No electricity from the power 

grid.

Check the electric circuit.

Steam leakage from lid

Sealing gasket is broken.

Send to repair and 

maintenance department.

Residue in the sealing gasket.

Clean and remove the 

residue. 

The sealing gasket was not 

properly installed.

Install the sealing gasket 

properly.