Karcher HDS 9/18-4M V2A*EU-I 1.077-805 - Инструкция по эксплуатации - Страница 30

– 5

Figure 5

Figure 6



Completely roll off the high-pressure 
hose from the hose drum.



Rotate the hose drum until the screwed-
on semibowl is pointing toward the top. 
Loosen all three screws and remove the 
loosened semibowl.

Figure 7



Unlatch the fastening clamp for the high-

pressure hose and pull the hose out.



Route the new high-pressure hose 

through the intended hose guide and 

the deflection pulley at the bottom of the 

appliance.



Slide the hose nipple all the way into the 

knot section of the hose drum and se-

cure with the fastening clamp.



Replace the half bowl.

For connection values refer to technical 
specifications



Connect the supply hose (minimum 

length 7.5 m, minimum diameter 3/4“) to 

the water connection point of the ma-

chine and at the water supply point (for 

e.g. a tap). 

Note:

 The supply hose is not included.

If you want to suck in water from an exter-
nal vessel, the following modification is 
necessary:

Figure 8



Remove the system care bottle.



Release and remove the cover of the 

system care.



Remove water connection from the fine 

filter.



Unscrew the fine filter from the pump 
head.

Figure 9



Remove the system care reservoir.



Unscrew the top supply hose to the 
swimmer container.

Figure 10



Connect the top supply hose at pump 
head.



Replug the rinse line of the detergent 
dosing valve.



Connect suction hose (minimum diame-
ter 3/4“) with filter (accessory) to the 
water connection point. 

–

Max. suck height: 0.5 m

Until the pump sucked in water, you should:



Set the pressure/quantity regulation at 
the pump unit to maximum quantity.



Close the dosing valve for the detergent.



Danger

Never suck in water from a drinking water 
container. Never suck in liquids which con-
tain solvents like lacquer thinner, petrol, oil 
or unfiltered water. The sealings within the 
device are not solvent resistant. The spray 
mist of solvents is highly inflammable, ex-
plosive and poisonous.

Note:

 Assembly in reverse order. Ensure 

that the solenoid valve cable on the reser-
voir of the system care is not pinched.

–

For connection values, see technical 
data and type plate.

–

The electrical connections must be 
done by an electrician according to IEC 
60364-1. 



Danger

Danger of injury by electric shock.

–

Unsuitable extension cables can be 
hazardous. Only use extension cables 
outdoors which have been approved for 
this purpose and labelled with a suffi-
cient cable cross section:

–

Always unwind extension lines com-
pletely.

–

The plug and coupling of the extension 
cable used must be watertight.

Installing the replacement 

high-pressure hose (appliances 

without hose drum)

Installing the replacement 

high-pressure hose (appliances 

with hose drum)

Water connection

Suck in water from vessel

Power connection

29

EN