Karcher HDS 801 В - Инструкция по эксплуатации - Страница 19

– 5



Press the safety clip back into the hand-
spray gun. The hose can be pulled out 
max. 1 mm if it has been installed cor-
rectly. Otherwise, it means the disc has 
been installed wrongly (picture C).

–

For connection values refer to technical 
specifications

According to the applicable regula-
tions, the appliance must never be 
used on the drinking water supply 
without a system separator. Use a 
suitable system separator manufactured by 
KÄRCHER; or, as an alternative, a system 
separator as per EN 12729 Type BA. Water 
flowing through a system separator is con-
sidered non-drinkable. 

Caution

Always connect the system separator to 
the water supply, never directly to the appli-
ance!



Connect the supply hose (minimum 
length 7.5 m, minimum diameter 3/4“) to 
the water connection point of the ma-
chine and at the water supply point (for 
e.g. a tap). 



Open the water supply.

Note:

 The supply hose is not included.

–

When fitted with the appropriate acces-
sories, this high-pressure cleaner can 
draw in surface water, e.g. from water 
butts or ponds.

–

Suction height max. 1m.



Danger

Never suck in water from a drinking water 
container. Never suck in liquids which con-
tain solvents like lacquer thinner, petrol, oil 
or unfiltered water. The sealings within the 
device are not solvent resistant. The spray 
mist of solvents is highly inflammable, ex-
plosive and poisonous.



Connect suction hose (minimum diame-
ter 3/4“) with filter (accessory) to the 
water connection point. 



Set dosing value for detergent to "0". 



Danger

Risk of explosion!
Do not spray flammable liquids.



Danger

–

Place the appliance on firm surface. 

–

The high pressure cleaner must not be 
used by children. (Risk of accident on 
account of improper use of the appli-
ance).

–

The high pressure spray generates high 
levels of noise when the appliance is in 
use. Risk of hearing impairment.  Al-
ways use proper ear-protection aids 
while working with the appliance.

–

The water jet coming out of the high 
pressure nozzle causes the gun to re-
coil. Further, an angular spray pipe can 
cause additional torque. Hence hold the 
spray pipe and gun firmly. 

–

Never direct the water jet on to persons, 
animals, the appliance itself or electrical 
components. 

–

Vehicle tyres/ tyre valves may be 
cleaned only with a minimum spray dis-
tance of 30 cm. Otherwise, the high 
pressure spray can cause damage to 
the vehicle tyre/ tyre valve. The discol-
ouring of the tyre is the fhe first sign of 
damage. Damaged vehicle tyres are a 
source of danger.

–

Do not spray materials contains asbes-
tos or other health-hazardous sub-
stances. 

–

The operator must wear proper safety 
gear to be protected against the water 
sprays. 

–

Pay attention to ensure that all screws 
of all connecting hoses are tightened 
properly. 

–

The lever of the hand spray gun must 
not be locked during the operation.

Water connection

Suck in water from vessel

Operation

19

EN