Мойки высокого давления Karcher HDS 801 В - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
– 4
–
If the hand spray gun is closed, the
overflow valve opens and the high pres-
sure pump diverts the water back to the
pump suction side. Thus the permissi-
ble working pressure is not exceeded.
–
The overflow valve is set by the manu-
facturer and sealed. Setting only by
customer service.
–
The safety valve opens when the over-
flow valve is defective.
–
The safety valve is set by the manufac-
turer and sealed. Setting only by cus-
tomer service.
The thermo-valve opens when the permis-
sible water temperature is exceeded and
lets out the hot water into the open.
The pressure switch switches off the burner
when the working pressure falls below the
minimum value and switches it on again
when it is exceeded.
몇
Warning
Risk of injury! Device, tubes, high pressure
hose and connections must be in faultless
condition. Otherwise, the appliance must
not be used.
Caution
In case of lacteous oil inform Kärcher cus-
tomer service immediately
Before using for the first time, cut off the
tip of the lid of the oil tank on the water
pump.
Check oil level in the oil tank.
Do not operate the appliance if the oil level
has fallen below "MIN".
Add oil if required (see technical speci-
fications).
Follow the instructions given in the sec-
tion "Safety Notes"!
Read the operating instructions of the
engine manufacturer before start-up
and follow the safety instructions care-
fully.
Check oil level of the engine.
Do not operate the appliance if the oil level
has fallen below "MIN".
If required, top up oil carefully.
Fill the fuel tank with unleaded petrol.
Do not use 2-speed mixture.
Caution
Risk of damage to the fuel pump on ac-
count of dry running. Fill up the fuel tank up
to this mark even for cold water operations.
Danger
Risk of explosion! Only refill diesel oil or
light fuel oil. Unsuitable fuels, e.g. petrol,
are not to be used.
Refill fuel.
Close tank lock.
Wipe off spilled fuel.
Mount the nozzle on the spray pipe
(markings on the adjustment ring at the
top).
Connect ray tube to hand spray gun
Connect the high pressure hose to the
high pressure connection point of the
machine.
Figures A-C
Lever out the safety clip of the hand
spray gun using a screw-driver (Picture
A).
Place the hand-spray gun upside down
and insert the end of the high pressure
hose till the end. Ensure that the lose
disc falls right below on the hose end
(Picture B).
Overflow valve
Safety valve
Thermo-valve at the pump
Pressure switch
Start up
Check oil level of the high pressure
pump
Motor
Refill fuel
Install hand spray gun
Installing spare high pressure hose
18
EN
