Karcher HD 13/18 S PLUS*EU-II 1.292-102 - Инструкция по эксплуатации - Страница 18

– 4

몇

Danger

Danger of injury by electric shock.
The appliance may only be connected to al-
ternating current.
The appliance may only be connected to an 
electrical supply which has been installed in 
accordance with IEC 60364.
The voltage indicated on the type plate 
must correspond to the voltage of the elec-
trical source.
The minimum fuse rating required at the 
socket outlet is (see technical specifica-
tions).
The maximum tolerable mains impedance 
at the electrical contact point (see Techni-
cal Data) must not be exceeded.
The appliance should always be connected 
to the electrical mains using a plug. It is for-
bidden to permanently connect the appli-
ance to the power supply. The plug is only 
for mains separation.
Check the power cord with mains plug for 
damage before every use. If the power cord 
is damaged, please arrange immediately 
for the exchange by an authorized custom-
er service or a skilled electrician.
The plug and coupling of the extension ca-
ble used must be watertight.
Use the extension cord that has an ade-
quate cross-section (see "Technical Data") 
and unwind it fully from the cable drum.
Unsuitable extension cables can be haz-
ardous. Only use extension cables out-
doors which have been approved for this 
purpose and labelled with a sufficient cable 
cross section:

For connection values, see type plate/tech-
nical data.

몇

Warning

Observe regulations of water supplier. 
According to the applicable regula-
tions, the appliance must never be 
used on the drinking water supply 
without a system separator. Use a 
suitable system separator manufactured by 
KÄRCHER; or, as an alternative, a system 
separator as per EN 12729 Type BA. Water 
flowing through a system separator is con-
sidered non-drinkable. 

Caution

Always connect the system separator to 
the water supply, never directly to the appli-
ance!

For connection values refer to technical 
specifications



Connect the supply hose (minimum 
length 7.5 m, minimum diameter 3/4“) to 
the water connection point of the ma-
chine and at the water supply point (for 
e.g. a tap). 

Note

The supply hose is not included.



Open the water supply.



Screw the suction hose with filter (order 
no. 4.440-238.0) to the water connec-
tion.



Deaerate the appliance:
Unscrew the nozzle. 
Switch on the appliance and let it run 
until the water exiting is bubble-free. 



Switch off the appliance and fit the noz-
zle again. 

Start up

Electrical connection

Water connection

Connection to the water supply

Drawing in water from open reservoirs

18

EN