Karcher HD 10 35 PB E Cage - Инструкция по эксплуатации - Страница 22

22 

English

–

Never direct the water jet on to persons, 
animals, the appliance itself or electrical 
components. 

–

The jet must not be directed by the user 
at him/herself or at other persons to 
clean clothing or footwear.

–

Do not use the appliance when there are 
other persons around unless they are 
also wearing safety gear. 

–

Vehicle tyres/ tyre valves may be 
cleaned only with a minimum spray dis-
tance of 30 cm. Otherwise, the high pres-
sure spray can cause damage to the 
vehicle tyre/ tyre valve.  The discolouring 
of the tyre is the fhe first sign of damage.   
Damaged vehicle tyres are a source of 
danger.

–

Do not spray materials contains asbes-
tos or other health-hazardous substanc-
es. 

–

The operator must wear proper safety 
gear to be protected against the water 
sprays. 

–

Pay attention to ensure that all screws of 
all connecting hoses are tightened prop-
erly. 

–

The lever of the hand spray gun must not 
be locked during the operation.

Î

Open the water supply.

Î

Start the engine according to the operat-
ing instructions of the engine manufac-
turer. 

Î

Unlock the safety lock at the hand-spray 
gun by pressing it.

Î

Press the lever on the hand spray gun.

몇

Warning

The handgun is subjected to a recoil force 
when the water jet is discharged. Make sure 
that you have a firm footing. Hold the hand-
gun and spray lance firmly.

The appliance is equipped with the following 
nozzles:

„

Power nozzle, 25° spray angle

– High pressure flat spray (25°) for large 

dirt areas

Note

To prevent damage due to too much pres-
sure, always position high pressure ray first 
from a greater distance towards object to be 
cleaned.

– For strong contaminations

Î

Release the lever on the trigger gun.

Note

When the lever of the hand spray gun is re-
leased, the engine continues to run at zero 
speed. The water thus circulates within the 
pump and gets heated.  When the cylinder 
head at the pump has reached the maximum 
permissible tempertaure (80 °C), the therm-
valve on the pump opens and lets out the hot 
water into the open.

Cooling can be hastened while using com-
pressed water from the water supply pipes: 

Î

Pull the lever of the hand spray gun for 2 
- 3 minutes so that the circulating water 
cools down the cylinder head. 

After operating the water using saline water 
(sea water), open the hand spray gun and 
rinse the appliance for at least 2 - 3 minutes 
using tap water. 

Î

Release the lever on the trigger gun.

Î

Set the appliance switch at the engine to 
OFF and close the fuel supply valve. 

Î

Shut off water supply.

Î

Activate hand spray gun until device is 
pressure less.

Î

Use the safety catch to secure the hand-
gun lever.

Î

Remove the water inlet hose from the 
appliance.

Î

Store the hand spray gun and spray pipe 
in the accessory mount.

Turning on the Appliance

High pressure operation

Power nozzle

Rotor nozzle (accessory)

Interrupting operation

Turn off the appliance.