IPC Portotecnica GALAX-H4 D1310 P4М230 40910 IDAC - Инструкция по эксплуатации - Страница 23

English

- 23 -

- Water cleaners with the 

"Total Stop” device should 

be  considered  as  off  when 

the omnipolar switch is in 

the “O” position or the plug 

is unplugged from the sock-

et. 

- When the water cleaner is not 

used, close the safety device 

on the handle. (fig. 10)

- Dry use of the water cleaner 

causes serious damage to 

pump gaskets.

FIG. 10

USING THE ACCESSORIES.

The high pressure washer has a nozzle with a flat  angle jet for 

cleaning large surfaces.

Warning

Aim the jet from a certain distance to avoid damage caused by 

the high pressure.

ROTARY HEAD (optional accessory)

The high pressure washer can be fitted with a head with rotary 

nozzle to clean the most stubborn dirt.

Danger:

Aim the jet from a certain distance to avoid damage caused by 

the high pressure. 

Do not aim the jet at people, animals or electrical sockets.

STOPPING THE CLEANER

1

)  Switch  off  the  burner  by  turning  the  pressure  regulator  to 

pos. "0" (fig. 8B).

2

) Let the cleaner run with cold water only  for at least 30 seconds 

to cool down the boiler. 

3

) Stop the cleaner by turning the selector switch to pos. "0" 

(fig. 8A).

4

) Discharge the pressure from the H.P. hose by pressing the 

trigger on the gun.

5

) 

Disconnect the water cleaner from the mains electricity 

supply via the omnipolar switch or by unplugging the plug from 

the socket.

6

) Turn off the water supply tap (fig. 6A).

Warning

- If the water cleaner is left, even temporarily, turn it off by using 

the omnipolar switch or by unplugging the plug from the socket.

FIG. 8

FIG. 9

USING 

THE CLEANER 

CONTROL PANEL

A

 - On/off switch

B

 - Temperature regulator 

C

 - Detergent control tap (if 

available).

D

 - 

Pressure gauge.

STARTING THE CLEANER 

1

) Turn on the water supply tap (fig. 6A).

2

) Connect the water cleaner to the mains electricity supply via 

the omnipolar switch or by plugging the plug into the socket.

3

) Start the cleaner by turning the selector switch to pos. 1 

(fig. 8A).

Warning

The high pressure water jet generates a reaction force in the 

lance. Keep a firm grip on the lance handle.

4

) Press the trigger on the gun and begin washing.

5

) To use the cleaner with hot water, turn the temperature regu-

lator (fig. 8B) to the recommended washing values.

For  some  models  turn  the  ignition  switch  (fig.  8A)  on  to  the 

hot  water  position  before  effecting  the  operations  described 

in this point.

Warning

In water cleaners with the “Total Stop” system, the motor starts 

and stops when the lever on the lance handle is actioned or 

released.

Danger

Do not block the handle lever in the delivery position.

IMPORTANT!

To  eliminate  any  impurities 

or air bubbles from the wa

-

ter circuit we advise starting 

the cleaner for the first time 

without the lance and letting 

the  water  run  out  for  a  few 

seconds.

Impurities  could  block  the 

nozzle and cause malfun-

ction (fig. 9). 

!

!

!

!

!

!

A

B

C

D