DEFORT DPW-1650 93728502 - Инструкция по эксплуатации - Страница 8

8

GB

- EXPLOSION 

HAZARD.

  DO NOT tamper with or alter the calibration of the 

safety valve.

-  HAZARDOUS ALTERATION OF OPERATING PER-

FORMANCE.

  DO NOT alter the original diameter of the spray 

head nozzle.

- ACCIDENT 

HAZARD.

  DO NOT leave the cleaner unattended.
-  SHORT CIRCUIT HAZARD.
  DO NOT move the cleaner by pulling on the electrical 

cable.

SAFETY “MUSTS”

-  SHORT CIRCUIT HAZARD.
  All electrical conductors MUST BE PROTECTED
  against the water jet.
-  ELECTRIC SHOCK HAZARD.
  The cleaner MUST ONLY BE CONNECTED to a 

correctly earthed power supply.

  -  Use a Residual Current Device (RCD) of not more 

than 30 mA, at the plug socket when using this appli-
ance.

- INJURY 

HAZARD.

  The high pressure may cause materials to bounce 

off surfaces at speed; therefore protective clothing 
and safety goggles MUST BE WORN.

-  ACCIDENTAL START-UP HAZARD.
  Before doing work on the cleaner, REMOVE the 

plug.

- INJURY 

HAZARD.

  Before pressing the trigger, GRIP the gun 

fi

 rmly  to 

counteract the recoil.

- CONTAMINATION 

HAZARD.

  COMPLY WITH the requirements of the local water 

supply company. According to DIN 1988, power-jet 
cleaners may only be connected to the mains drink-
ing water supply if a back

fl

 ow preventer valve with 

drain facility is installed in the supply hose.

- ACCIDENT 

HAZARD.

  Maintenance and/or repair of electrical components 

MUST be carried out by quali

fi

 ed staff.

- INJURY 

HAZARD.

  DISCHARGE residual pressure before
  disconnecting the cleaner hose.
- ACCIDENT 

HAZARD.

  Before using the cleaner, CHECK every time that 

the screws are fully tightened and that there are no 
broken or worn parts.

-  EXPLOSION AND ELECTRIC SHOCK HAZARD.
  Only USE detergents which will not corrode the 

coating materials of the high pressure hose/electri-
cal cable.

- INJURY 

HAZARD.

  ENSURE that all people or animals keep a minimum 

distance of 16 yd. (15m) away.

SAFETY VALVE

The safety valve also functions as a pressure limiting 
valve. When the gun trigger is released, the safety 
valve opens and the water recirculates through the 
pump inlet.

●

  In versions not equipped with TSS device, do not 

operate the cleaner for more than 1-2 minutes with 
the gun closed as this could damage the seals.

●

  Protect the cleaner from freezing during the winter.

●

  Do not obstruct the ventilation grilles during opera-

tion.

●

 The cross-section of any extension cables used 

must be proportional to their length, i.e. the longer 
the extension cable, the greater the cross-section; 
cables with a protection level of “IPX5” must be 
used.

●

  Position the cleaner AS NEAR POSSIBLE to the wa-

ter supply.

●

  The packaging is easily recyclable, and must be dis-

posed of in compliance with the regulations in force 
in the country of installation.

●

  Use the cleaner only with accessories and replace-

ment parts authorized by the manufacturer. The use 
of original accessories and replacement parts will 
ensure safe, trouble-free operation.

●

  The cleaner must be used standing on a secure, sta-

ble surface.

●

 Avoid unintentional 

fi

 ring of the trigger. Do not carry 

the lance/ trigger assembly with your hand over the 
trigger. Always use the trigger lock mechanism.

●

  Ensure that the safety lock on the trigger is used, 

when you have stopped using the pressure washer 
to prevent accidental operation. (

fi

 g 5)

SAFETY “MUST NOTS”

-  EXPLOSION OR POISONING.
  DO NOT use the cleaner with in

fl

 ammable or toxic 

liquids, or any products which are not compatible 
with the correct operation of the cleaner.

- INJURY 

HAZARD.

  DO NOT direct the water jet towards people or ani-

mals.

-  ELECTRIC SHOCK HAZARD.
  DO NOT direct the water jet towards the unit itself, 

electrical parts or towards other electrical equip-
ment.

-  SHORT CIRCUIT HAZARD.
  DO NOT use the cleaner outdoors in case of rain.
- INJURY 

HAZARD.

  DO NOT allow children or incompetent persons to 

use the cleaner.

-  ELECTRIC SHOCK HAZARD.
  DO NOT touch the plug and/or socket with wet 

hands.

-  ELECTRIC SHOCK AND SHORT CIRCUIT HAZ-

ARD.

  DO NOT use the cleaner if the electrical cable is 

damaged.

- EXPLOSION 

HAZARD.

  DO NOT use the cleaner if the high pressure hose is 

damaged.

- ACCIDENT 

HAZARD.

  DO NOT jam the trigger in the operating position.
- ACCIDENT 

HAZARD.

Check that the data plates are af

fi

 xed to the cleaner, if 

not, inform your dealer. Cleaners without plates must 
NOT be used as they are unidenti

fi

 able and potentially 

dangerous.