Bosch GHP 5-14 - Инструкция по эксплуатации - Страница 13

 English | 

13

Bosch Power Tools

F 016 L72 355 | (16.8.12)

If the plug is not suitable for your socket outlets, it should be 

cut off and an appropriate plug fitted in its place by an author-

ised customer service agent. The replacement plug should 

have the same fuse rating as the original plug.

The severed plug must be disposed of to avoid a possible 

shock hazard and should never be inserted into a mains sock-

et elsewhere.
For products 

not sold in GB

:

WARNING:

 For your safety, it is required that the plug at-

tached to the machine is connected with the extension cord. 

The coupling of the extension cord must be protected against 

splash water, be made of rubber or coated with rubber. The 

extension cord must be used with a cable strain relief.
Drawing in water from open reservoirs
– Screw the suction hose with filter (special suction kit part 

no. F 016 800 335) to the water connection.

– Switch on the appliance in low pressure mode.

– Let the appliance run for appx. 10 seconds, then switch 

off. Repeat the procedure a couple of times until water ex-

iting is smooth and bubble free.

To prevent damage to the appliance, do not allow it to operate 

dry.

Operation

Starting

Attach water supply hose (not supplied) to the mains water 

supply and machine.
Connect the product to the mains supply ensuring that the 

mains switch is in the off position.
Open water tap.
Press the safety lock   to release the trigger. Fully press the 

trigger   until there is a constant flow of water to clear the air 

from the machine and water supply hose. Release trigger.
Point the power gun   downwards. Press the trigger safety lock   

to release the trigger. Fully press the trigger.
Operate on/off switch.

Autostop function

The machine is designed to switch off the motor when the trig-

ger is released on the gun.

Working Advice

General

Ensure that the pressure washer is on level ground.
Do not overreach with the high pressure hose or move the 

pressure washer by pulling the hose, this could cause the ma-

chine to become unstable and fall over.
Do not kink or drive a motor vehicle over the high pressure 

hose. Do not expose the high pressure hose to sharp edges or 

corners.
Never use the roto nozzle to clean motor vehicles.
Do not tamper with or adjust the safety valve setting. 

Working advice for cleaning with detergents

f

Only use cleaning agents suitable specifically for high 

pressure washers.

We recommend that you use detergent sparingly for the sake 

of the environment. Observe the recommended dilution on 

the detergent label.
By offering you an individualised range of cleaning and pre-

serving agents, Bosch guarantees troublefree operation of 

the unit.

Recommended cleaning method

Step 1: Loosening dirt

Spray on detergent sparingly and allow to react for a short 

time.

Step 2: Removing dirt

Spray off the loosened dirt with the high-pressure spray.

Note: 

When cleaning a vertical surface spray off dirt/deter-

gent from the bottom and work in an upwards direction. Rinse 

from the top and work downwards.

Troubleshooting

Problem

Possible Cause

Corrective Action

Motor refuses to start

Plug not connected

Connect plug

Mains socket faulty

Use another socket

Fuse faulty / blown

Replace fuse

Extension cable damaged

Try without extension cable

Motor protector has activated

Allow to cool for 15 minutes

Frozen

Wait for pump/water supply hose/acces-

sory to thaw

Motor stops

Fuse faulty / blown

Replace fuse

Wrong mains voltage

Check that mains voltage corresponds to 

specifications on the model tag

Motor protector has activated

Allow to cool for 15 minutes

Fuses blow

Fuses incorrectly rated

Change to a mains supply higher than the 

pressure washer amp consumption

OBJ_BUCH-1762-001.book  Page 13  Thursday, August 16, 2012  10:03 AM