Bosch GHP 5-13 C (0.600.910.000) - Инструкция по эксплуатации - Страница 11

 English | 11

Bosch Power Tools

1 609 92A 3EP | (14.7.17)

Entsorgung

Hochdruckreiniger, Zubehör und Verpackungen sollen einer 

umweltgerechten Wiederverwertung zugeführt werden.

Werfen Sie Hochdruckreiniger nicht in den Haus-

müll!

Nur für EU-Länder:
Gemäß der Europäischen Richtlinie 2012/19/EU über Elekt-

ro- und Elektronik-Altgeräte und ihrer Umsetzung in nationa-

les Recht müssen nicht mehr gebrauchsfähige Elektro- und 

Elektronikgeräte getrennt gesammelt und einer umweltge-

rechten Wiederverwertung zugeführt werden.

Änderungen vorbehalten.

English

Safety Notes

Explanation of symbols

General hazard safety alert.

Never direct the water jet 

at people, animals, the unit 

or electric components.

Warning: High pressure jets can be dan-

gerous if subject to misuse.

According to the applicable 

regulations, the appliance 

must never be used on the 

drinking water network without a 

system separator. Use a separator as 

per IEC 61770 Type BA. 

Water flowing though a system sepa-

rator is considered not drinkable. 

For self priming use special suction 

kit 3 m long (F 016 800 335). 

Safety Notes for pressure washer

Read all safety warnings 

and all instructions. Failure 

to follow the warnings and in-

structions may result in electric shock, 

fire and/or serious injury.
The warning and information signs 

attached to the unit provide impor-

tant information for safe operation.

Apart from the information in the op-

erating instructions comply with the 

general safety regulations and regu-

lations for the prevention of acci-

dents.
Connecting to the mains



The voltage indicated on the rating

plate must correspond to the voltage

of the power source.



We recommend that this equipment

is only connected into a socket which

is protected by a circuit-breaker that

would be actuated by a 30 mA residu-

al current.



This is a class 

I

 unit and may only be

connected to properly earthed power

sources.



Remove the plug from socket when-

ever the machine is left unattended

for any period.



The electric supply installation

should comply with IEC 60364-1.



If the supply cord is damaged, it must

be replaced by the manufacturer, its

service agent or similarly qualified

persons in order to avoid a hazard.



If the plug is damaged, pay attention

to the following:



Plugs and sockets situated near the

work site or outdoors should be to

class IP 55 of BS 5490 to provide ad-

equate protection against ingress of

water, etc. and cable entries require

effective sealing. Rubber shrouds

OBJ_BUCH-1751-003.book  Page 11  Friday, July 14, 2017  12:19 PM