Bosch AQT 33-10 06008A7000 - Инструкция по эксплуатации - Страница 12

12

 | English 

F 016 L70 993 | (10.6.13)

Bosch Power Tools

Operation

Starting

Attach water supply hose (not supplied) to the mains water 
supply and machine.

Connect the product to the mains supply ensuring that the 
mains switch is in the off position.

Open water tap.

Press the safety lock (back button on the gun handle) to re-
lease the trigger. Fully press the trigger until there is a con-
stant flow of water to clear the air from the machine and water 
supply hose. Release trigger. Press the safety lock (front but-
ton on the gun handle).

Turn button on main switch. Point the power gun downwards. 
Press the trigger safety lock to release the trigger. Fully press 
the trigger.

Autostop function

The machine is designed to switch off the motor when the trig-
ger is released on the gun.

Working Advice

General

Ensure that the pressure washer is on level ground.

Do not overreach with the high pressure hose or move the 
pressure washer by pulling the hose, this could cause the ma-
chine to become unstable and fall over.

Do not kink or drive a motor vehicle over the high pressure 
hose. Do not expose the high pressure hose to sharp edges or 
corners.

Never use a roto nozzle to clean motor vehicles.

Working advice for cleaning with detergents



Only use cleaning agents suitable specifically for high 
pressure washers.

We recommend that you use detergent sparingly for the sake 
of the environment. Observe the recommended dilution on 
the detergent label.

Recommended cleaning method

Step 1: Loosening dirt

Remove the nozzle from the lance to give a low pressure flow 
and spray on the detergent sparingly. 

Step 2: Removing dirt

Spray off the loosened dirt with the high-pressure spray.

Note: 

When cleaning a vertical surface spray off dirt/deter-

gent from the bottom and work in an upwards direction. Rinse 
from the top and work downwards.

Troubleshooting

Problem

Possible Cause

Corrective Action

Motor refuses to start

Plug not connected

Connect plug

Mains socket faulty

Use another socket

Fuse faulty / blown

Replace fuse

Extension cable damaged

Try without extension cable

Motor protector has activated

Allow to cool for 15 minutes

Frozen

Wait for pump/water supply hose/acces-
sory to thaw

Motor stops

Fuse faulty / blown

Replace fuse

Wrong mains voltage

Check that mains voltage corresponds to 
specifications on the model tag

Motor protector has activated

Allow to cool for 15 minutes

Fuses blow

Fuses incorrectly rated

Change to a mains supply higher than the 
pressure washer amp consumption

Motor starts but no pressure

Nozzle partly blocked

Clean nozzle

Motor “sounds” but fails to start

Insufficient power supply

Check that the voltage of the mains pow-
er supply line is the same as that on the 
plate.

Voltage loss due to use of extension cable Check characteristics of extension cable

Appliance not used for a long period of 
time

Contact your Bosch Service Centre

Problems with TSS (Total Stop System) 
device

Contact your Bosch Service Centre

OBJ_BUCH-1870-004.book  Page 12  Monday, June 10, 2013  10:08 AM