ARDESTO URM-85M60 - Инструкция по эксплуатации - Страница 24

EN

25

UNPACKING YOUR FREEZER

WARNING: Use two or more people to move Freezer.
Failure to do so can result in back or other injury.

·  Remove tape and any labels from your Freezer before using(except the rating label).
·  To remove any remaining tape or glue, rub the area briskly with your thumb.
·  Tape or glue residue can also be easily removed by rubbing a small amount of  

   liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.
·  Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive  

   cleaners to remove tape or glue. These products can damage the surface of your Freezer.
· When moving the Freezer, do not tilt the Freezer beyond 45°from upright position.

CLEANING BEFORE USE

After you remove all of the packaging materials, (especially 

the foam between outside condenser and cabinet should 

be removed) clean the inside of your Freezer before using it.

SPACE REQUIREMENTS

WARNING: Keep flammable materials and vapors, such as gasoline, away 

form Freezer.
Failure to do so can result in death, explosion, fine or burns.
NOTE:

Before performing any type of installation, disconnect the Freezer from the

electrical source. When you are finished, connect the Freezer to the electrical source 

and reset the control to the desired setting.

·  To ensure proper ventilation for your Freezer, allow for 200mm space on each 

side between walls, 200mm space between back of your Freezer and the wall, 

and 300mm space between counter top and the roof or ceiling.

·  If you are installing your Freezer next to a fixed wall, leave sufficient space on the

hinge side to allow for the door to swing open.

·  Never install your Freezer near heat source and direct sun shins.