Kraft KF-HS180WNF - Инструкция по эксплуатации - Страница 33

33

UPRIGHT FREEZER

USER GUIDE

TROUBLESHOOTING

During operation, if any malfunctions are detected that the consumer cannot eliminate 

on  their  own,  it  is  necessary  to  contact  the  service  workshop  for  the  repair  of  freezer 
equipment.

But before contacting the repair service, read this section. This list includes the most 

common cases that are not the result of poor assembly quality or poor-quality materials 
used in this device.

 ATTENTION!  Before  troubleshooting,  you  must  disconnect  the  product  from 

the  mains.  Troubleshooting  that  is  not  described  in  this  manual  should  only  be 

carried out by a qualified electrician or a competent technician.

Malfunction

Possible cause

Solution

The freezer does not 
work.

The plug is not plugged in or not fully 
plugged in.

Plug the plug into the wall outlet.

The fuse is blown or faulty.

Check the fuse. Replace it if necessary.

The plug is faulty.

The fault is fixed by an electrician.

The freezer is 
exceptionally cold.

The temperature is set to very low.

Adjust the temperature to higher values.

The buildup of ice on 
the sealing strip.

The sealing tape is not airtight.

Heat the sealing tape with warm air, 
using a hair dryer to dry your hair. At the 
same time, straighten the tape with your 
hands, giving it the necessary shape to 
ensure tightness.

Products are not frozen 
completely.

The temperature is set incorrectly.

Set the desired temperature.

The door had been open for too long

Do not leave the door open for longer 
than necessary.

A large amount of warm food has been 
placed in the chamber over the past 24 
hours.

Set a lower temperature.

The freezer is located next to the heat 
source.

Please read the instructions for installing 
and placing the freezer again.

Uncharacteristic 
sounds.

The freezer is not installed correctly in 
height.

Adjust feets.

The freezer is close to the wall or other 
objects

Carefully remove the freezer 
compartment.

A part of the freezer, such as a tube, 
touches the wall or other parts of it.

If necessary, carefully bend the 
interfering part, observing all necessary 
safety measures.

 ATTENTION! Troubleshooting that is not spelled out in this manual can only be 

carried out by a qualified specialist.

In case of malfunctions that are not specified in this manual, you should immediately 

contact  an  authorized  service  center,  specifying  the  type  of  problem  and  the  model 
of  your  freezer.  Only  original  spare  parts  can  be  used  for  repairs.  Unqualified  repair 
removes the device from warranty service.