Kraft BD (W) 135QX - Инструкция по эксплуатации - Страница 30

30

М О Р О З И Л Ь Н Ы Й   Л А Р Ь

C H E S T   F R E E Z E R

Р У К О В О Д С Т В О   П О   Э К С П Л УАТА Ц И И   •   U S E R   G U I D E

soft brush or a vacuum cleaner. (* If the condenser is at back of appliance).

•  After everything is dry place appliance back into service.

Troubleshooting

 CAUTION! 

Before troubleshooting, disconnect the power supply. Only a qualified 

electrician of competent person must do the troubleshooting that is not in this manual.

Important!

  There  are  some  sounds  during  normal  use  (compressor,  refrigerant 

circulation).

Problem

Possible cause

Solution

Appliance dose 
not work.

Mains plug is not plugged in or 
is loose.

Insert mains plug.

Fuse has blown or is 
defective.

Check fuse, replace if necessary.

Socket is defective.

Mains malfunctions are to be 
corrected by an electrician.

Appliance 
freezes too 
much.

Temperature is set too cold 
orthe appliance runs at MAX 
setting.

Turn the temperature regulator to a 
warmer setting temporarily.

The food is not 
frozen enough.

Temperature is not properly 
adjusted.

Please look in the initial 
Temperature Setting section.

Heavy build-up 
of frost on the 
door seal.

Door was open for an 
extended period.

Open the door only as long as 
necessary.

A large quantity of warm food 
was placed in the appliance 
within the last 24 hours.

Turn the temperature regulation to a 
colder setting temporarily.

The appliance is near a heat 
source.

Please look in the installation 
location section.

Door seal is not air-tight.

Carefully warm the leaking sections 
of the door seal with a hair dryer 
(on a cool setting). At the same time 
shape the warmed door seal by 
hand such that it sits correctly.

Unusual noises.

The appliance is touching the 
wall or other objects.

Move the appliance slightly.

Acomponent, e.g. a pipe, on 
the rear of the appliance is 
touching another part of the 
appliance orthe wall.

If necessary, carefully bend the 
component out of the way.

If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data 

here, refer to the rating plate.