Материнские платы GIGABYTE GA P55A UD3R rev 1 0 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
- 53 -
BIOS Setup
Onboard LAN Boot ROM
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip.
(Default: Disabled)
Onboard IDE Controller (IT8213 Chip)
Enables or disables the IDE controller integrated in the IT8213 chip. (Default: Enabled)
eSATA Controller (JMB362 Chip, eSATA Connectors)
Enables or disables the SATA controller integrated in the JMB362 chip. (Default: Enabled)
eSATA Ctrl Mode (JMB362 Chip, eSATA Connectors)
Enables or disables RAID for the SATA controller integrated in the JMB362 chip or configures the SATA
controller to AHCI mode.
IDE
Disables RAID for the SATA controller and configures the SATA controller to IDE
mode. (Default)
AHCI
Configures the SATA controller to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specification that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
RAID
Enables RAID for the SATA controller.
GSATA Controller (Marvell 9128 Chip, GSATA3_6/7 Connectors)
Enables or disables the SATA controller integrated in the Marvell 9128 chip. (Default: Enabled)
GSATA Ctrl Mode (Marvell 9128 Chip, GSATA3_6/7 Connectors)
Allows you to decide whether to configure the SATA controller integrated in the Marvell 9128 chip to
AHCI mode.
IDE
Configures the SATA controller to IDE mode. (Default)
AHCI
Configures the SATA controller to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specification that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
GSATA RAID Configuration (Marvell 9128 Chip, GSATA3_6/7 Connectors)
Allows you to configure RAID for the Marvell 9128 SATA controller. Refer to Chapter 5, "Configuring
SATA Hard Drive(s)," for instructions on configuring a RAID array.
Onboard Serial Port 1
Enables or disables the first serial port and specifies its base I/O address and corresponding interrupt.
Options are: Auto, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled.
Onboard Parallel Port
Enables or disables the onboard parallel port (LPT) and specifies its base I/O address and correspond
-
ing interrupt. Options are: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
Selects an operating mode for the onboard parallel (LPT) port. Options are: SPP (Standard Parallel Port)
(default), EPP (Enhanced Parallel Port), ECP (Extended Capabilities Port), ECP+EPP.
