Материнские платы GIGABYTE GA 8I865PE775 G RH rev 4 9 - инструкция пользователя по применению, эксплуатации и установке на русском языке. Мы надеемся, она поможет вам решить возникшие у вас вопросы при эксплуатации техники.
Если остались вопросы, задайте их в комментариях после инструкции.
"Загружаем инструкцию", означает, что нужно подождать пока файл загрузится и можно будет его читать онлайн. Некоторые инструкции очень большие и время их появления зависит от вашей скорости интернета.
BIOS Setup
- 35 -
English
First / Second / Third Boot Device
Floppy
Select your boot device priority by Floppy.
LS120
Select your boot device priority by LS120.
Hard Disk
Select your boot device priority by Hard Disk.
CDROM
Select your boot device priority by CDROM.
ZIP
Select your boot device priority by ZIP.
USB-FDD
Select your boot device priority by USB-FDD.
USB-ZIP
Select your boot device priority by USB-ZIP.
USB-CDROM Select your boot device priority by USB-CDROM.
USB-HDD
Select your boot device priority by USB-HDD.
LAN
Select your boot device priority by LAN.
Disabled
Disable this function.
Password Check
System
The system can not boot and can not access to Setup page will be denied if the
correct password is not entered at the prompt.
Setup
The system will boot, but access to Setup will be denied if the correct password
is not entered at the prompt. (Default value)
(Note) This item will show up when you install a processor which supports this function.
When LAN Cable Is Functioning Normally...
If no cable problem is detected on the LAN cable connected to a Gigabit hub or a 10/100 Mbps
hub, the following message will appear:
Start detecting at Port.....
Link Detected --> 100Mbps
Cable Length= 30m
Link Detected Displays transmission speed
Cable Length Displays the approximate length of the attached LAN cable
Note: The Gigabit hub will only operate at a speed of 10/100Mbps in MS-DOS mode; it will
operate at a normal speed of 10/100/1000 Mbps in Windows mode or when the LAN Boot ROM
is activated.
When a Cable Problem Occurs...
If a cable problem occurs on a specified pair of wires, the
Status
field will show
Short
and the
length shown will be the approximate distance to the fault or short.
Example:
P a i r 1 - 2 S t a t u s = S h o r t / L e n g t h = 1 . 6 m
Explanation: A fault or short might occur at about 1.6m on Pair 1-2.
Note: Pair 4-5 and Pair 7-8 are not used in a 10/100 Mbps environment, their
Status
fields will
show
Open
, and the length shown is the approximate length of the attached LAN cable.
