ASRock H610M-HDV - Инструкция по эксплуатации - Страница 22

English

18

J_SENS E

OUT2_L

1

MIC_RET

PRESENCE#

GN D

OUT2_R

MIC2_R

MIC2_L

OUT_RET

Serial ATA3 Connectors
Right Angle:
(SATA3_2: 
see p.1, 2, No. 8) (Upper)
(SATA3_3: 
see p.1, 2, No. 8) (Lower)
Vertical:
(SATA3_0: 
see p.1, 2, No. 9)
(SATA3_1: 
see p.1, 2, No. 10)

These four SATA3 
connectors support SATA 
data cables for internal 
storage devices with up to 6.0 
Gb/s data transfer rate.

USB 2.0 Header
(9-pin USB_5_6)
(see p.1, 2, No. 7)

There is one header on this 
motherboard. This USB 
2.0 header can support two 
ports.

USB 3.2 Gen1 Header
(19-pin USB3_3_4)
(see p.1, 2, No. 6)

There is one header on this 
motherboard. This USB 3.2 
Gen1 header can support 
two ports.

Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.1, 2, No. 15)

This header is for connecting 
audio devices to the front 
audio panel. 

1

I n t A _ P B _ D +

D u m m y

I n t A _ P B _ D -

G N D

I n t A _ P B _ S S T X +

G N D

I n t A _ P B _ S S T X -

I n t A _ P B _ S S R X +

I n t A _ P B _ S S R X -

V b u s

V b u s

V b u s

I n t A _ PA _ S S R X -

I n t A _ PA _ S S R X +

G N D

I n t A _ PA _ S S T X -

I n t A _ PA _ S S T X +

G N D

I n t A _ PA _ D -

I n t A _ PA _ D +

SA

TA3_2

SA

TA3_3

SA

TA3_1

SA

TA3_0

D U M M Y

G N D

G N D

+ B

- B

+ A

- A

U S B _ P W R

U S B _ P W R

1

1.  High Definition Audio supports Jack Sensing, but the panel wire on the chassis 

must support HDA to function correctly. Please follow the instructions in our 
manual and chassis manual to install your system.

2.  If you use an AC’97 audio panel, please install it to the front panel audio header by 

the steps below: 
A. Connect Mic_IN (MIC) to MIC2_L. 
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L. 
C. Connect Ground (GND) to Ground (GND). 
D. MIC_RET and OUT_RET are for the HD audio panel only. You don’t need to 
connect them for the AC’97 audio panel. 
E. To activate the front mic, go to the “FrontMic” Tab in the Realtek Control panel 
and adjust “Recording Volume”.